Руководство По Работе для Brother CM350
63
4
e
While holding the mat level and lightly
inserting it under the feed rollers on the left and
inserting it under the feed rollers on the left and
right sides of the feed slot, press
in the
operation panel.
• For details, see “Loading the Mat” on page 27.
X
The “Start/Stop” button in the operation panel
lights up.
lights up.
f
Press the “Start/Stop” button to start scanning.
■ Creating Cutting Data
The procedure for creating cutting data differs
depending on the mode.
depending on the mode.
Grayscale recognition mode
a
Check the scanned image, and then touch the
“OK” key.
“OK” key.
b
In the image trim screen, use the touch pen to
drag
to trim the image to the size to be
imported.
X
If cutting lines are created, the outline of the
scanned illustration will be black.
scanned illustration will be black.
• Touch
to change the minimum object size
that will be detected and the conversion threshold.
For details, see “Adjusting Image Detection Levels”
on page 72.
For details, see “Adjusting Image Detection Levels”
on page 72.
• Touch
or
to edit the imported
cutting data. For details, see “Advanced Cutting
Functions for “Direct Cut”” on page 64.
Functions for “Direct Cut”” on page 64.
c
Touch the “OK” key to confirm the trimmed
area.
area.
X
Only the cutting lines appear.
d
Press the “Start/Stop” button to start cutting.
• For details on unloading the mat after cutting,
follow the procedure under “Unloading the Mat”
on page 28.
on page 28.
Color recognition mode
a
In the image trim screen, use the touch pen to
drag
to trim the image to the size to be
imported.
Memo
• Trimming the image to the desired size can
reduce the amount of time required to convert it
to cutting data.
to cutting data.
b
Touch the “OK” key to confirm the trimmed
area.
area.
X
The image is converted to cutting data.