Руководство По Работе для Brother LX3014
10
1
THREADING THE MACHINE
Winding the bobbin
This section describes how to wind the thread onto the bobbin.
a
Pull up the spool pin as far as possible, and
then put a spool of thread on this pin.
then put a spool of thread on this pin.
b
Pass the thread around the pre-tension disk.
a Pre-tension disk
c
Pass the end of the thread through the hole on
the bobbin from the inside of the bobbin.
the bobbin from the inside of the bobbin.
d
Put the bobbin onto the bobbin winder shaft and
slide the bobbin winder shaft to the right. Turn
the bobbin clockwise, by hand, until the spring
on the shaft slides into the groove of the bobbin.
• Align the notch on bobbin to the spring on
slide the bobbin winder shaft to the right. Turn
the bobbin clockwise, by hand, until the spring
on the shaft slides into the groove of the bobbin.
• Align the notch on bobbin to the spring on
the shaft.
a Spring on the shaft
b Groove of the bobbin
b Groove of the bobbin
e
Turn on the sewing machine.
a Pre-tension disk
b Bobbin winder shaft
c Bobbin
b Bobbin winder shaft
c Bobbin
● We designed the bobbin that comes with this machine. If you use bobbins from other models, the
machine will not work properly. Only use the bobbin that comes with this machine or bobbins of the
same type (part code: SA156, SFB: XA5539-151).
same type (part code: SA156, SFB: XA5539-151).
a 11.5 mm (7/16 inches)
1 Pulling it in as
far as possible.
CAUTION
Actual size
This model
Other models
● If the spool of thread is not in the right place,
the thread may tangle on the spool pin.
CAUTION
Click!