Справочник Пользователя для Samsung RS21HFTPN

setting up _13

01 SETTING

Remove any residual matter inside
the puriﬁ er. (Model with the puriﬁ er)

- Open the main water tap to check whether water

is running through the water tube on the water
inlet side of the purifier.

- If water does not come out through the line,

check whether the tap is open.

- Leave the tap open until clean water is running

out and any residual matter that built up during
manufacturing has been removed.

Attach the puriﬁ er lock-clip.

- Hold the purifier lock-clip in the appropriate

position (under the sink for example) and fix it
tightly into place where to screw.

Secure the puriﬁ er in position.

- Fix the purifier in position, as shown in the figure

on the right.

Replacement Instructions

1.  Shut off water supply.
2.  Note the Flow direction on the filter.
3.  Insert water supply tube into the inlet side of the

filter until the tube stop.

4. After inserting tube, put together the clip strongly.

The Clip fix the tube.

5. Turn on the water and check for leaks. If leaks

occur, repeat step 1,2,3,4. If leaks persist,
discontinue use and call your supporting dealer.

6. Flush filter for 5 minutes before use.

COUPLER “A”

TAP

COUPLER

SIDE OF

SIDE OF
PURIFIER

PURIFIER

WATER INLET

WATER INLET
SIDE OF PURIFIER

SIDE OF PURIFIER

LINE OUTLET

90 degree

PURIFIER WATER

CAUTION

Locking Clip

Insert Locking Clip After

Insert Locking Clip After
tube seated

tube seated

WATER SUPPLY

INLET SIDE

PERMEAT

FLOW DIRECTION

Note :

You must also ensure

that the cut is square and not
at any sort of angle as this
could cause a leak

WATER LINE

PURIFIER

WATER

OUTLET SIDE OF

PURIFIER

Purifier lock-clip

WATER TUBE

Purifier lock-clip

PURIFIER

DA99-02028D-08.indb 13

2014. 7. 19.

8:41

2014. 7. 19.

8:41