Справочник Пользователя для Samsung SR20K9350WK
ENGLISH-33
troubleshooting
Symptom
checklist
the PoWeRbot is not working at
all.
f
Check if the emergency switch is on.
f
Check if all the icons are displayed on display panel.
f
Check if the battery of POWERbot is depleted.
– When "Lo" is displayed, carry POWERbot to the docking station to
charge it.
f
Replace the batteries (AAA type) when the remote controller is not
working.
working.
the PoWeRbot is stopped during
cleaning process.
f
When "Lo" is displayed on the display panel, carry POWERbot to the
docking station to charge it.
docking station to charge it.
f
When POWERbot is stuck by the obstacles such as cord, threshold
etc, pick it up to remove it from the obstacle.
etc, pick it up to remove it from the obstacle.
– If any fabrics or strings are caught in the drive wheel, turn off the
emergency switch and remove the fabrics or strings before using it
again.
again.
Suction power is weak.
f
If the "Filter inspection indicator" is on, turn off the emergency switch
and clean the dustbin.
and clean the dustbin.
f
When there's too much dust in the dustbin, suction power may get
weakened. Turn off the emergency switch and empty the dustbin.
weakened. Turn off the emergency switch and empty the dustbin.
f
If the intake (on bottom of POWERbot) is blocked by foreign matters,
turn off the emergency switch and remove foreign matter from the
intake.
turn off the emergency switch and remove foreign matter from the
intake.
f
When noise suddenly increase, turn off the emergency switch and
empty the dustbin.
empty the dustbin.
the PoWeRbot cannot find the
docking station.
f
Check if there's power failure or whether the power plug is
unplugged.
unplugged.
f
Remove any obstacles around the docking station that may disturb
POWERbot from returning to the docking station.
POWERbot from returning to the docking station.
f
When there's foreign matters on the charge pins that affects
charging, clean the foreign matter.
charging, clean the foreign matter.
the PoWeRbot passes through
the Virtual guard.
f
If the batteries are depleted, replace them. (2 type D (LR20)
batteries)
batteries)
f
If the lamp is off, check if the Virtual guard is turned off and turn it
on.
on.
the PoWeRbot suddenly cleans
diagonally.
f
Check if the docking station is installed along the grain of wooden
floors or tiles.
floors or tiles.
f
It may clean in diagonal direction for moving to another area in
shortest route, or it made contact with any obstacles in that angle,
or if it was charged at the charged at an angle, or grain of the
wooden/tile floor is in that direction.
shortest route, or it made contact with any obstacles in that angle,
or if it was charged at the charged at an angle, or grain of the
wooden/tile floor is in that direction.
Point cleaning is not working.
f
If you point the red light directly on POWERbot, it may not move to
desired direction.
desired direction.
– Point the red light on the floor within 39 in (1 m) around POWERbot.
✻
✻
Do not use the point cleaning under direct sunlight, bright light or on
dark floors.
dark floors.
SR9300K_EN_DJ68-00743J-00_SA.indd 33
2016-07-15 오후 3:48:07