Руководство По Установке для Samsung Gas Cooktop (NAK7750 Series)

English 15

Installation instructions

1. Locate electrical outlet and gas shut-off

valve beneath cabinet.

2. Apply the foam tape around the edge of

the cutout opening. Do not overlap the
foam strips.

• The foam strip helps avoid damage

to the underside of the cooktop from
debris and helps the cooktop sit flat on
uneven counters.

3. Protect surface of cooktop

• Place a towel or tablecloth onto the

countertop.

Correct installation

4. With bottom side first, gently put the

cooktop down. Then, slightly lift up the
rear to remove the protective rubber for
the Wi-Fi module.

• Make sure the front of the countertop is

parallel to the cooktop

• Make final check that all required

clearances are met.

Front of unit

Gas inlet

Power cord

Hold Down Bracket Installation

Hold down

bracket holes

5. Secure the cooktop to the countertop

using the two provided hold-down
brackets as shown.

Hold down bracket install guide

M4 L10 screw

M4 L16 screw

Case 1.

Countertop

Side wall of

undercounter

cabinet

Hold down

bracket

L75 screw

Case 2.

Countertop

Chassis

Hold down

bracket

Chassis

M4 L10 screw

NOTE

Smart Connect module can/must be detached before installation of the cooktop in
folowing cases:
• The consumer doesn’t need to Smart connect function.
• Installation is not possible because the Smart Connect module protrudes against

the rear wall of the countertop.

• The downdraft hood is installed and protrudes against the Smart Connect

module.

The Cover must be installed in place of Smart connect module if Smart connect
module has been removed. Please read following instructions on how to detach
Smart connect module.

Install_NA9300K_DG68-00841A-01_EN+MES+CFR.indb 15

12/12/2016 9:31:35 PM