Справочник Пользователя для Samsung VR9000H POWERbot Vacuum Cleaner with CycloneForce, 250W
ENGLISH-34
Symptom
checklist
"Filter inspection indicator" is on
even after the dustbin has been
emptied.
f
Use POWERbot after turning off the emergency switch and then
turning it back on.
turning it back on.
f
Empty the dustbin again and re-clean the filter thoroughly.
PoWeRbot moves around at the
same place.
f
Dust sensor mode is on.
– The dust sensor mode is on by default. When the POWERbot
passes through a dusty area, it moves around that area to focus on
cleaning.
cleaning.
f
POWERbot moves around an area and the "DUST" is on the display
panel even though there's no dust at the surrounding area.
panel even though there's no dust at the surrounding area.
– Check if foreign matters are caught between the dustbin and Pet
brush and then remove them.
PoWeRbot does not clean a
certain area.
f
Check if the docking station is installed near a narrow passage or
door, and reinstall it in the other areas.
door, and reinstall it in the other areas.
– If the docking station is installed near a narrow passage or door, the
POWERbot cannot pass through the passage or doorsill.
the battery usage time of the
Virtual guard is too short.
f
Check if you're using manganese drycell batteries and replace the
batteries with new ones. (2 type D (LR20) batteries)
batteries with new ones. (2 type D (LR20) batteries)
I have installed the Samsung
Smart Home app, but, the
PoWeRbot fails to be connected.
f
You can use the product after connecting the wireless router and the
POWERbot through Easy-Setup according to the procedure.
POWERbot through Easy-Setup according to the procedure.
I fail to log into the Samsung
account.
f
Check your ID and password on the screen of the Samsung
account.
account.
there appears a message saying
there is a failure during easy-
Setup.
f
You may have failed temporarily due to the distance from the
wireless router or other obstacles. Please try again after a while.
wireless router or other obstacles. Please try again after a while.
the products do not work
even though the smart phone
is normally connected to the
PoWeRbot.
f
Turn off the Samsung Smart Home app and then run it again, or
disconnect the smart phone from the wireless router and then
connect it again. Or turn off the power supply of the POWERbot,
turn it on, wait for a minute or longer, and then run the Smart Home
app again.
disconnect the smart phone from the wireless router and then
connect it again. Or turn off the power supply of the POWERbot,
turn it on, wait for a minute or longer, and then run the Smart Home
app again.
the functions of the Samsung
Smart Home App do not work.
f
Check if the Smart control blocking function of the POWERbot is
set. (When the Smart control is locked, the Wi-Fi indicator is turned
off.)
set. (When the Smart control is locked, the Wi-Fi indicator is turned
off.)
the Samsung Smart Robot
Vacuum App fails to get started.
f
Check if the POWERbot is connected to the wireless router.
PoWeRbot is not connected to
Wi-Fi.
f
Check the setting status of the wireless router.
Location recognizing function
does not operate.
f
Operate the POWERbot again near the area where it stopped
previously.
previously.
f
If the POWERbot does not recognize the surrounding environment
or starts the cleaning at the area more than 1 m around where it
stopped, the searching may be difficult.
or starts the cleaning at the area more than 1 m around where it
stopped, the searching may be difficult.
troubleshooting
SR9300K_EN_DJ68-00743J-00_SA.indd 34
2016-07-15 오후 3:48:07