Справочник Пользователя для Acer altos r510 mk2
81
5
Remove all hot-swap drive carriers. For instructions, see
“Removing a SATA or SCSI Hot-swap Hard Disk Drive.”
6
Set the backplane board in place so that the holes in the board fit
through the pegs in the bottom of the server chassis. See letter
“A” in the figure below.
through the pegs in the bottom of the server chassis. See letter
“A” in the figure below.
7
Slide the board to the left until it stops. Do not pull on any
components on the board – grasp only on the edges of the board.
See letter “B” in the figure.
components on the board – grasp only on the edges of the board.
See letter “B” in the figure.
8
Tighten the blue captive screw at the right side of the backplane
board. See letter “C” in the figure.
board. See letter “C” in the figure.
9
Connect the following cables to the backplane:
•
Front panel cable
•
Power cable
•
Flex cable. The cable indicates the end that is to be connected
to the backplane.
to the backplane.
•
(SCSI backplane only): SCSI Channel A cable. The cable
indicates the end that is to be connected to the backplane.
indicates the end that is to be connected to the backplane.
•
(SATA backplane only): SATA cable(s).
A
C
B