Справочник Пользователя для Acer altos r510 mk2
85
Installing the Heat Sink(s)
1
The heat sink has Thermal Interface Material (TIM) located on the
bottom of it. Use caution when you unpack the heat sink so you do
not damage the TIM.
bottom of it. Use caution when you unpack the heat sink so you do
not damage the TIM.
2
Set the heat sink over the processor, lining up the four captive
screws with the four posts surrounding the processor.
screws with the four posts surrounding the processor.
3
Loosely screw in the captive screws on the heat sink corners in a
diagonal manner (screw in one screw, then the screw located
diagonally to the first screw). Do not fully tighten one screw
before tightening another.
diagonal manner (screw in one screw, then the screw located
diagonally to the first screw). Do not fully tighten one screw
before tightening another.
4
Gradually and equally tighten each captive screw until each is
firmly tightened. Do not over-tighten the screws.
firmly tightened. Do not over-tighten the screws.
5
Reinstall and reconnect any parts you removed or disconnected to
reach the processor sockets.
reach the processor sockets.
6
Replace the server’s cover and reconnect the AC power cord. See
the documentation that accompanied your server chassis for
instructions on installing the server’s cover.
the documentation that accompanied your server chassis for
instructions on installing the server’s cover.