Инструкции По Монтажу для Apple power mac g5 late 2004
Power Mac G5 Hard Drive -
6
3. Pull the drive out of the drive bay, being careful not to touch the bottom of the drive.
(Figure 5)
Note:
If you encounter resistance, use a flatblade screwdriver to release the latches
on the drive bay rails as you pull the drive out of the bay. (See circled areas on the
illustration below.) If two drives are installed, remove the bottom drive first.
illustration below.) If two drives are installed, remove the bottom drive first.
Figure 5
Important:
If the printed circuit board (PCB) is exposed on the bottom of the hard drive,
hold the drive by its sides. To avoid damaging the replacement drive, take care not to touch
the PCB during installation.
the PCB during installation.