Справочник Пользователя для Alcatel-Lucent speedtouch 500

UPnP Commands

upnp config

Configure UPnP parameter(s).

SYNTAX:

EXAMPLE:

upnp config

[maxage = <number{60-999999}>] 
[defcservice = <interface_name>]
[writemode = <{full|natonly|readonly}>]
[safenat = <{disabled|enabled}>]
[preferredaddress = <ip-address>]

maxage

This parameter allows to configure how often the SpeedTouch™ 
sends a notification message to advertise its presence as an Internet 
Gateway Device  IGD) on the network.
Setting this parameter to a low value will increase the number of 
packets sent over time on the network, but will make the state of 
the device more up to date.
Default is 1800 seconds.

OPTIONAL

defcservice

This parameter allows to configure the connection service to be 
used by the DrSpeedTouch™ application during the troubleshooting 
process (only when several connection services are configured on 
the SpeedTouch™, else only the default connection service).

OPTIONAL

writemode

Choose the set of rules to limit remote access from UPnP. Choose 
between:

•

full: the host will accept all the UPnP SET and GET actions.

•

natonly: GET and NAT related SET actions will be accepted, all 
other actions will be ignored.

•

readonly: the UPnP control point will only be able to retrieve 
information, all the SET actions are ignored.

OPTIONAL

safenat

Enable / disable check on safe NAT entries.
If this check is enabled, all NAT create/delete requests for a LAN 
side IP address different from the source IP address of the UPnP 
message will be discarded.

OPTIONAL

preferredaddress

Preferred ip address for UPnP advertisements (enter 0.0.0.0 for 
none)

OPTIONAL

=>upnp config

ssdp max-age

: 1800

default connection service : PPPoA_1
write mode

: full

safe nat entries

: disabled

preferred address

:

=>