Справочник Пользователя для Alcatel-Lucent speedtouch 500

AutoPVC Commands

autopvc config

Configure autopvc

SYNTAX:

autopvc config

[mode = <{pseudo|passive|active}>]
[type = <{bridge|pppoerelay}>]
[opmode = <{partial|full}>]
[overwrite = <{disabled|enabled}>]
[peakrate = <number{0-27786}>]

mode

Select the autopvc mode:

•

pseudo: enable only pseudo-ILMI (VP/VC 15/16). When 
connection parameters are written to the MIB, display this 
information on CLI or web-interface but do not use these 
parameters for configuration.

•

passive: enable both ILMI (VP/VC 0/16) and pseudo-ILMI (VP/
VC 15/16). When connection parameters are written to the 
MIB, display this information on CLI or web-interface but do 
not use these parameters for configuration. (default)

•

active: enable both ILMI (VP/VC 0/16) and pseudo-ILMI (VP/VC 
15/16). When connection parameters are written to the MIB, 
use these parameters to configure phonebook entries, 
qosbook profiles and bind bridge or PPPoE interfaces on top.

OPTIONAL

type

Type of autopvc:

•

bridge (default)

•

pppoerelay: an ETHoA interface will be created, will be bound 
to the ILMI PVC and will be added to the PPPoE relay as relay 
port.

OPTIONAL

opmode

Operational autopvc mode:

•

partial: 

only read the ILMI VPC and VCC MIB tables

 (default)

•

full: 

read all supported MIB tables

OPTIONAL

overwrite

Enable/disable UBR peak rate overwrite.

OPTIONAL

peakrate

A number between 0 and 27786.
Represents the UBR peak rate (in kilobits per second).

Note

0 indicates the linerate

OPTIONAL