Руководство По Установке для Alcatel-Lucent omniaccess 6000
OmniAccess 6000 200W Power Supply Unit
3
2. Make sure the power switch on the power supply to be installed is Off
(
(
|).
3. Insert the power supply into the chassis.
Grasp the power supply by handle, keeping the LEDs on the left and power
switch on the right. Align the back of the module with the guide-rails in the
chassis power supply slot and gently slide in the module. Do not force the
module; it should slide in easily most of the way. There may be moderate
resistance when the power supply meets the connectors at the back of the
chassis. Press firmly to engage the connectors, but do not use excessive force.
switch on the right. Align the back of the module with the guide-rails in the
chassis power supply slot and gently slide in the module. Do not force the
module; it should slide in easily most of the way. There may be moderate
resistance when the power supply meets the connectors at the back of the
chassis. Press firmly to engage the connectors, but do not use excessive force.
4. Secure the power supply.
Use the screwdriver to push in the module’s captive fastening screws and turn
them clockwise until moderate resistance is felt. Do not over-tighten.
them clockwise until moderate resistance is felt. Do not over-tighten.
5. Attach the power cord to the power supply.
Plug an appropriate power cord into the power input socket. The socket
accepts a power cord with a standard IEC320 plug
accepts a power cord with a standard IEC320 plug
6. Attach the power cord to a proper electrical outlet.
Make sure that your site’s electrical systems can handle the switch’s power
load.
load.
Each standard power supply is rated at 200 W total and is auto-ranging to
accept 90-132/ 170-264 VAC, at 50 to 60 Hz.
accept 90-132/ 170-264 VAC, at 50 to 60 Hz.
Depending on the switch’s total power load, you may be required to increase
the capacity of your site’s electrical systems. Refer to the installation guide for
information on maximum power load.
the capacity of your site’s electrical systems. Refer to the installation guide for
information on maximum power load.
C
AUTION
—Never insert or remove a power supply while its power
switch is in the On (|) position. Make sure the power switch is Off (
|)
first.
C
AUTION
—For proper safety and performance, the power cord must be
rated to 10 A and conform to grounded electrical standards in the
country where the product is operated.
country where the product is operated.