Справочник Пользователя для Alcatel-Lucent ap70

Part 031644-00

May 2005

Mounting Slots

The keyhole-shaped slots on the back of the chassis are used for mounting the 
OmniAccess OAW-AP70.

Air Vents

These vents promote proper air circulation for cooling the device. Do not allow 
these vents to be obstructed by mounting equipment, network cables, or any 
other material.

Fold-Out Internal Antenna

This fold-out antenna allows the OmniAccess OAW-AP70 to be used upright 
on a table, shelf, ceiling, or wall. If you are configuring external antennas, the 
internal antenna can be left closed.

—The serial number and the model number are on the bottom of the fold 

out antenna panel.

Setting up an Alcatel AP typically consists of four stages:

1

Wireless LAN Planning—The administrator determines how many Alcatel 
APs will be needed for their wireless network strategy and where they will 
be deployed. This can be easily accomplished using Alcatel’s automated RF 
Plan site-survey software (available separately).

2

AP Provisioning—Provisioning provides each Alcatel AP with initial settings 
that allow it to locate the host Alcatel Wireless LAN Switch. Depending on 
the network topology and services, AP provisioning can be performed 
manually for each AP or plug-and-play for batches of APs.

AP provisioning is discussed in 

3

AP Deployment—Once provisioned, each AP can be physically installed at 
its intended place of operation.

AP deployment is covered in 

4

AP Configuration—The administrator defines the operational behavior for 
each Alcatel AP, such as RF characteristics and security features.

For AP configuration information, refer to the Alcatel AOS-W User Guide.