Справочник Пользователя для Aopen crw5232aaopro
Specification English
3.2.2 Rear Panel
1. Audio Output Connector
2. Device Configuration Jumper
3. IDE Connector
4. Power Connector
2. Device Configuration Jumper
3. IDE Connector
4. Power Connector
Name Features
Audio Output
Connector
Connector
Is able to be connected to a sound card audio
input and can use a sound card to listen to a CD
music
input and can use a sound card to listen to a CD
music
Device
Configuration
Jumper
Configuration
Jumper
Used when selecting the device configuration of
E-IDE. Don’t use jumpers to change anything
besides the device configuration. Configuration
changes become valid after power is turned off,
then on again. The device configuration jumper
will be set to Master as factory default setting
E-IDE. Don’t use jumpers to change anything
besides the device configuration. Configuration
changes become valid after power is turned off,
then on again. The device configuration jumper
will be set to Master as factory default setting
E-IDE Connector
Use a two-headed 40pin IDE cable and an IDE
connector head. Before connecting please switch
off the power supply
connector head. Before connecting please switch
off the power supply
Power Connector
Connect DC 5V/12V to the power connector
Be careful not to reverse the power connector when attaching it. A
reversed connection may cause damage to the equipment (not
covered by the warranty)
reversed connection may cause damage to the equipment (not
covered by the warranty)
Connecting or disconnecting E-IDE connectors while power is on
may result in a short circuit, causing damage to the equipment.
When connecting or disconnecting connectors, make sure to turn off
the power beforehand.
may result in a short circuit, causing damage to the equipment.
When connecting or disconnecting connectors, make sure to turn off
the power beforehand.
-- E-11 --