Справочник Пользователя для Aopen ap5t-org
iv
FCC Class B Radio Frequency
Declaration of Conformity
This equipment has been tested and found to comply with the limits for a Class
B Subassembly -CPU Board device, pursuant to Part 15 of FCC Rules.
Operation is subject to the following two conditions: 1. This device may not
cause harmful interference, and 2. This device must accept any interference
received, including interference that may cause undesired operation.
B Subassembly -CPU Board device, pursuant to Part 15 of FCC Rules.
Operation is subject to the following two conditions: 1. This device may not
cause harmful interference, and 2. This device must accept any interference
received, including interference that may cause undesired operation.
Equipment Classification
: FCC Class B Subassembly - CPU Board
Type of Product
: Intel Pentium PCI/ISA AT Motherboard
CPU Frequencies
: 200/180/166/150/133/120/100/90 MHz
Chipset(s)
: Intel 430TX
AP5T
Test To Comply
With FCC Standards
With FCC Standards
FOR HOME OR OFFICE USE
The limits of FCC Part 15 Class B are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
1.
Reorient or relocate the receiving antenna.
2.
Increase the separation between the equipment and receiver.
3.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
which the receiver is connected.
4.
Consult the dealer or an experienced radio/television technician for help.