Справочник Пользователя для Aopen i915gae
If you desire to change the default setting,
press Enter for selection list:
press Enter for selection list:
Disabled: You can choose this item if
there are only traditional IDE hard disks
had been installed on your system.
Disabling this item will also cancel the
detection of serial ATA hard disks during
POST, which will theoretically speed up
your boot-up time a little bit; however,
there are only traditional IDE hard disks
had been installed on your system.
Disabling this item will also cancel the
detection of serial ATA hard disks during
POST, which will theoretically speed up
your boot-up time a little bit; however,
please remember to re-adjust the setting here if you want to use serial ATA hard
disk later.
disk later.
Auto: This is factory default setting on this motherboard. Basically, if your system
functions properly, it is unnecessary to change it. The system will automatically
recognize PATA (IDE) as primary.
functions properly, it is unnecessary to change it. The system will automatically
recognize PATA (IDE) as primary.
Combined Mode: If you have traditional IDE hard disks and serial ATA hard disks
installed at the same time, then you can choose this mode. Under this mode, you
can randomly choose either IDE hard disks or serial ATA had disk as your first boot
device. But please note, IDE will exist with serial ATA in a mapping way, which
means it will occupy one of the serial Channel and leave you one serial Channel
only. When PATA Mode is set to primary, SATA3 and SATA4 will be set to secondary,
and when PATA Mode is set to secondary, SATA1 and SATA2 will be set to primary.
installed at the same time, then you can choose this mode. Under this mode, you
can randomly choose either IDE hard disks or serial ATA had disk as your first boot
device. But please note, IDE will exist with serial ATA in a mapping way, which
means it will occupy one of the serial Channel and leave you one serial Channel
only. When PATA Mode is set to primary, SATA3 and SATA4 will be set to secondary,
and when PATA Mode is set to secondary, SATA1 and SATA2 will be set to primary.
Enhanced Mode: If you are using the latest operating system (say, Windows XP,
Windows.NET Server), it is highly recommended that you select Enhanced Mode.
Under this mode the system will detect all six devices (traditional IDE x 2, Serial
ATA x 4) completely and function perfectly. But please note that PATA Mode is set
to primary under this mode.
Note: According to practical lab tests of us, there are no obvious
problems or mistakes happened when we set this mode under
Windows2000 operating system; however, it is not recommended by
Intel.
Windows.NET Server), it is highly recommended that you select Enhanced Mode.
Under this mode the system will detect all six devices (traditional IDE x 2, Serial
ATA x 4) completely and function perfectly. But please note that PATA Mode is set
to primary under this mode.
Note: According to practical lab tests of us, there are no obvious
problems or mistakes happened when we set this mode under
Windows2000 operating system; however, it is not recommended by
Intel.
SATA Only: You may select this mode if you install serial ATA hard disks only.
20