Справочник Пользователя для Aopen n250al

device [Recommended]'. Insert the driver diskette into floppy drive. Click
'Next' and complete the driver installation.

3. System will go through the enumeration process and install the driver. At the

end of the process, click 'Yes' to reboot your system when necessary.

4. See instructions in section 4 to verify controller was installed correctly.

7) Windows 98SE and Windows ME Fresh Installation Instructions

Follow the instructions in this section if you are performing a new installation of
Windows 98SE/ME and you wish to boot from a device attached to the SiI 3114
controller.

You may start up the Windows 98SE/ME installation from CD. If either your
Windows 98SE/ME CD or CD-ROM drive is not bootable, your can start up with
floppy diskettes.

1. Power off the system. Connect the hard drives to the SiI RAID controller and

insert the controller into a PCI slot. Power up the system

2. Put your Windows 98SE/ME CD into the CD-ROM/DVD drive, and the

Windows 98SE/ME boot diskette in the floppy drive if your system cannot
boot from the CD.

3. Follow the normal Windows 98SE/ME setup instructions to select your choice

for partition and file system.

4. Wait until Windows 98SE/ME finishes installing devices, regional settings,

networking settings, components, and final set of tasks, reboot the system.

5. After the system reboot, right click on 'My Computer' and select 'Properties'.

From the 'System Properties’, select 'Device Manager', right click on the '? PCI
RAID controller' and select 'Properties' from the pop-up menu.

6. Click ‘Driver’,'Update Driver’ and select 'Automatic search for a better driver

[Recommended]'. Insert the driver diskette into floppy drive. Click 'Next' and
complete the driver installation.

7. System will go through the enumeration process and install the driver. At

the end of the process, click ‘Yes’ to reboot your system.

8. See instructions in section 4 to verify controller was installed correctly.

8) First time installing SiI RAID driver with existing Windows 98SE/ME

If you have an existing Windows 98SE/ME system and just obtained a Silicon