Справочник Пользователя для Aopen mx3l
Hardware Installation
2-16
III. Buffered and non-buffered: This motherboard supports non-buffered
DIMMs. You can identify non-buffered DIMMs and buffered DIMMs
according to the position of the notch, following figure is for your reference:
according to the position of the notch, following figure is for your reference:
buffered
non-buffered
Reserved
Because the positions are different, only non-buffered DIMMs can be inserted
into the DIMM sockets on this motherboard. Although most of DIMMs on
current market are non-buffered, we still suggest you to ask your dealer for
the correct type.
current market are non-buffered, we still suggest you to ask your dealer for
the correct type.
IV. 2-clock and 4-clock signals: Although both of 2-clock and 4-clock signals
are supported by this motherboard, we strongly recommend choosing 4-
clock SDRAM in consideration of reliability.
clock SDRAM in consideration of reliability.
Tip: To identify 2-clock and 4-clock SDRAM, you
may check if there are traces connected to
golden finger pin 79 and pin 163 of the SDRAM. If
there are traces, the SDRAM is probably 4-clock;
Otherwise, it is 2-clock.
may check if there are traces connected to
golden finger pin 79 and pin 163 of the SDRAM. If
there are traces, the SDRAM is probably 4-clock;
Otherwise, it is 2-clock.
V. Parity: This motherboard supports standard 64 bit wide (without parity) and
72-bit wide (with parity) DIMM modules.
There is no jumper setting required for the memory size or type. It is
automatically detected by the system BIOS, and the total memory size is to
add them together. The maximum is 768MB.
LX chipset can only use 3V EDO or SDRAM, so we can mix EDO and SDRAM.
Every DIMM socket can be EDO or SDRAM. For EDO, maximum is 256MB.
For SDRAM, maximum is 128MB.
For SDRAM, maximum is 128MB.
Total Memory Size = Size of DIMM1 + Size of DIMM2 + Size of DIMM3
Note: 768MB memory is achieved by using double-
sided buffered EDO DIMMs.
sided buffered EDO DIMMs.