Справочник Пользователя для ASUS p8000
18
IV. Hardware Setup
IV
. Hardware Setup
AP8000 Hardware Reference Guide
• 4-2. Motherboard
Motherboard
Spacers
Spacers
Place four spacers in the ar-
eas circled on the chassis.
eas circled on the chassis.
Spacer
Install the
Baseboard
Baseboard
A metal baseboard is required to
add stability to the motherboard.
A rubber pad is placed between
the metal board and motherboard
to prevent shorting. Align the rub-
ber pad over the metal baseboard
so that the holes match. Align the
XG-DLS motherboard over the
rubber pad and metal baseboard
so that the screws match up with
the motherboard’s screw holes.
add stability to the motherboard.
A rubber pad is placed between
the metal board and motherboard
to prevent shorting. Align the rub-
ber pad over the metal baseboard
so that the holes match. Align the
XG-DLS motherboard over the
rubber pad and metal baseboard
so that the screws match up with
the motherboard’s screw holes.
Place and tighten three captive nuts in
the corner locations as circled.
the corner locations as circled.
Motherboard
Motherboard
Screws
Screws
Place eight screws in the areas
circled on the motherboard. The
four screws used with the moth-
erboard spacers are longer than
the others. (See page 20 for
samples.) Be careful not to over-
tighten the screws. Doing so may
damage your motherboard.
circled on the motherboard. The
four screws used with the moth-
erboard spacers are longer than
the others. (See page 20 for
samples.) Be careful not to over-
tighten the screws. Doing so may
damage your motherboard.