Справочник Пользователя для att 5840
Wall Installation
1
Connect the power cord and
telephone line cord to the underside
of the corded base, as shown
(figure a).
telephone line cord to the underside
of the corded base, as shown
(figure a).
2
Position the mounting bracket as
shown (figure b).
shown (figure b).
3
Feed the telephone line cord through
the hole in the center of the mounting
bracket (figure b), align the bracket
with the base, and slide it into the
hole on the base as shown (figure c).
the hole in the center of the mounting
bracket (figure b), align the bracket
with the base, and slide it into the
hole on the base as shown (figure c).
4
Lock the mounting bracket in place
(figure d).
(figure d).
5
Plug the telephone line cord into a
modular wall jack, and mount the
base on the wall (figure e).
a)
modular wall jack, and mount the
base on the wall (figure e).
a)
Align holes on base with mounting
studs on wall jack.
studs on wall jack.
b)
Place power cord as shown.
c)
Pull base down on mounting studs
until it locks into place.
until it locks into place.
6
Plug the power cord into an
electrical outlet not controlled by a
wall switch (figure e).
electrical outlet not controlled by a
wall switch (figure e).
Use only the power cord supplied
with this product. If you need a
replacement, call 1 800 222–3111.
with this product. If you need a
replacement, call 1 800 222–3111.
7
Follow Steps 3–5 in “Table/Desktop
Installation.”
Installation.”
5
INST
ALLA
TION
INST
ALLA
TION
figure a
figure b
figure c
figure d
figure e
5840_CIB_2ATT 2002.11.7 5:47 PM Page 5