Справочник Пользователя для Audiovox ccs-100
TROUBLE SHOOTING
WIRING - 10 PIN CONNECTOR
Note : If the brown, green, or yellow wires do not test properly, proceed immediately to the testing of the
4 pin control switch testing.
POS
WIRE COLOR
FUNCTION
9
Black
Always continuity to ground
3
Red
Always + 12 VDC
1
Brown
+ 12 VDC with Ignition switch and cruise control switch ON.
O VDC with Ignition switch or cruise control switch OFF.
O VDC with Ignition switch or cruise control switch OFF.
4
Purple
+ 12 VDC when the brake pedal is pressed.
0 VDC when the brake pedal is released.
To test the Green and Yellow wires, the Ignition Switch and Cruise Control Switch must both be turned on and
left ON.
left ON.
8
Green
+ 12 VDC when the SET / COAST switch is pressed.
0 VDC when the SET / COAST switch is released.
0 VDC when the SET / COAST switch is released.
6
Yellow
+ 12 VDC when the RESUME / ACCEL switch is pressed.
0 VDC when the RESUME / ACCEL switch is released.
CLOSED CIRCUIT SWITCH
8
Green
0 VDC when the SET / COAST switch is pressed.
+12 VDC when the SET / COAST switch is released.
+12 VDC when the SET / COAST switch is released.
6
Yellow
+ 12 VDC when the RESUME / ACCEL switch is pressed.
0 VDC when the RESUME / ACCEL switch is released.
10
Blue
Engine RPM. Increasing AC Voltage with engine speed.
2
Grey
Vehicle Speed Sensor:
Factory VSS: Roll vehicle forward (approx. 3 feet), in neutral with
Ignition and Cruise Control On. L.E.D. should flash.
Magnets or Fords: Drive at 30 M.P.H. approx. 500-1000 milivolts
AC.
Factory VSS: Roll vehicle forward (approx. 3 feet), in neutral with
Ignition and Cruise Control On. L.E.D. should flash.
Magnets or Fords: Drive at 30 M.P.H. approx. 500-1000 milivolts
AC.
OPEN CIRCUIT SWITCH
4 PIN CONTROL SWITCH TESTING
Red - +12 VDC with Ignition Switch ON.
Brown - Same as Pos 1 above.
Green - Same as Pos 8 above.
Yellow - Same as Pos 6 above.
Red - +12 VDC with Ignition Switch ON.
Brown - Same as Pos 1 above.
Green - Same as Pos 8 above.
Yellow - Same as Pos 6 above.
-11-