Справочник Пользователя для ati all-in-wonder x800

58  Using TV Out

The TV screen may become scrambled during the initial Windows® logo 
display. This distortion is only a temporary effect, and your screen will be 
restored within a few seconds.

During start up, your ALL-IN-WONDER® X800 Series will go through a 
sequence of mode settings, during which your TV display will remain 
blank. This process takes only a few seconds and programs the TV display.

Access the Windows® 

. Double-click 

.

Click the 

 tab and then the 

 button.

Click the 

 tab. Click the 

 button.

Click the enable button 

 or disable button 

accordingly.

Click 

 or 

 to save the changes.

For information about how to adjust TV display features, right-click the 

, point to 

, then point to 

.

A TV cannot be left connected to the graphics card if two analog monitors 
are connected to your ALL-IN-WONDER® X800 Series card, even if the 
TV is off and not enabled in the software.

Similarly, an analog monitor connected to the DVI-I connector should not 
be left connected to your ALL-IN-WONDER® X800 Series card when TV 
Out is enabled. In both cases, your ALL-IN-WONDER® X800 Series will 
become overloaded, resulting in a dim image on all devices.

Using your TV for your computer’s display can be useful, however, the 
display on your monitor may change or look squashed. This distortion 
occurs because the display adjusts to fit the dimensions of your TV. To 
correct the monitor’s display, use the monitor’s control buttons to adjust its 
display size and position. 

Some single-frequency monitors may not work with TV display enabled. If 
you experience problems when TV display is enabled, disable TV display 
to restore your monitor’s display.