Справочник Пользователя для Avision av3800

 

2-4 

 

 

 
When you have several devices on a SCSI chain, 
you may need to adjust the SCSI ID selector 
setting located on the back of the scanner. This 
setting assigns a specific "device ID" to the 
scanner.  If the assignment conflicts with an 
existing SCSI device, please select a new ID. (See 
Figure 2-2) 

Note: The factory setting for scanner is ID 6.  
Usually, ID 0 is assigned to an internal hard disk 
drive, and ID 7, ID 8 ,and ID 9 are not in actual use. 

Using a suitable tool, turn the selector switch until 
the arrow points to the desired ID number. 

2.3  Setting SCSI Terminator   

The scanner is equipped with a built-in terminator 
switch on the rear of the scanner. (See Figure 2-2). 
The scanner is equipped with a built-in terminator 
switch on the rear of the scanner. Turn the 
terminator switch on if the scanner is to be 
connected to the computer as the only or the last 
SCSI device. Turn the terminator switch off if the 
scanner is to be located between the computer and 
the other SCSI device.