Брошюра для australian-monitor amis120p

Power Output

120 Watts RMS

Maximum Load

40 Ohms @ 70 Volts

Power Bandwidth

60Hz - 17kHz (- 3dB)

Frequency Response

60Hz - 23kHz (- 3dB)

Total Harmonic Distortion

0.5% @ 1kHz rated power

Signal To Noise Ratio

-80dB 

Input Sensitivity

700mV

Outputs

70V, 4 Ohm, 8 Ohm

Controls

One gain control on rear of the unit via flathead screwdriver control

Indicators

Power “on” LED

Power Source

120VAC 60Hz 3 pin IEC connector; 24VDC

Power Consumption

300 Watts

Protection

Current Limiter protection, plus AC and DC fuses

Dimensions/Weight

3.5" H x 19" W x 11" D (Chassis Dimensions only). 26.5lb

Rack Mounting

Standard

ARCHITECTURAL AND ENGINEERING SPECIFICATIONS

The 120 watt power amplifier shall be designed to run 70 volt line audio systems. The unit shall also feature

a 4 and 8 ohm output. The amplifier may be desk or rack mounted.

The amplifier must be capable of delivering 120 watts into an 40 ohm inductive load with less than 0.5% dis-

tortion measured at 1kHz and with system hum and noise of -80dB or better. Internal current limiting shall

protect the amplifier from both overload and overdrive conditions.

The amplifier shall be an Australian Monitor Installation Series model AMIS120P.

UL APPROVED

PO Box 3126, Lynnwood, WA 98046 • Voice: 425-673-5175 • Fax: 425-673-7825

• Website: 

www.australianmonitor.com • Email: sales@australianmonitor.com

AUSTRALIAN MONITOR AUDIO INC.