Справочник Пользователя для HP ams dl320
Hardware options installation 28
•
All DIMMs installed must be the same speed (DDR2 PC4200). Do not install DIMMs supporting
different speeds.
different speeds.
•
If only a single DIMM is installed, HP recommends installing it in slot 1A.
BIOS detects the DIMM population and sets the system as follows:
•
Single-bank mode: DIMMs installed in one bank only.
•
Dual-bank interleaved mode: DIMMs installed in both banks with equal bank capacities.
The following table lists some, but not all, possible configurations. For best performance, HP recommends
dual-bank interleaved mode configurations.
dual-bank interleaved mode configurations.
Slot 1A
Slot 2A
Slot 3B
Slot 4B
Total Memory
Mode
512
MB
— — — 512
MB Single-bank
512 MB
—
512 MB
—
1 GB
Dual-bank interleaved
1
GB
— — — 1
GB
Single-bank
1 GB
—
1 GB
—
2 GB
Dual-bank interleaved
1 GB
1 GB
1 GB
1 GB
4 GB
Dual-bank interleaved
Installing DIMMs
1.
Power down the server ("
2.
Remove the server from the rack ("
3.
Remove the access panel ("
" on page
4.
Open the DIMM slot latches.
5.
Install the DIMM.
6.
Install the access panel ("
7.
Install the server into the rack ("
" on page
Hard drive options
The server provides non-hot plug capability through an embedded SATA controller. To obtain SAS or
SATA hot-plug capability, install an optional controller.
SATA hot-plug capability, install an optional controller.