Инструкции По Обслуживанию для HP laserjet 3390, 3392 all-in-one

To remove and replace the all-in-one tray 2 pickup roller or the tray 2 or tray 3 separation pad, see

 or 

.

●

#2 Phillips screwdriver with a magnetic tip and a 152-mm (6-inch) shaft length

●

Small flatblade screwdriver

●

#8 torx driver

●

Needle-nose pliers

●

ESD mat (if one is available)

●

Penlight (optional)

Always use a Phillips screwdriver (callout 1). Do not use a pozidrive screwdriver

(callout 2) or any motorized screwdriver. These can damage screws or screw threads.

Do not pull directly on the wires to disconnect them. Always pull on the plastic body

of a connector to avoid damaging the connector wires.

  Phillips and pozidrive screwdriver comparison

●

Remove all media from the all-in-one.

●

Turn off the power using the power switch.

●

Unplug the power cable and interface cable(s).

●

Place the all-in-one on an ESD mat (if one is available). If an ESD workstation or mat is not
available, ground yourself by touching the sheet-metal chassis before touching an ESD-sensitive
part.

●

Remove the print cartridge. See 

.

●

Remove the tray 2 cassette.

●

Lift the all-in-one off of the optional tray 3 (if it is installed).

ENWW

Introduction

109