Инструкции По Обслуживанию для HP omnibook 510

 Add-On 

Devices 

 

Replacing the Hard Disk Drive 

  

Reference 

Guide 

103 

2.  Notice that the hard drive has a pin connector attachment at one end. Carefully 

remove this connector from the end of the drive. Work alternately at each end so that 
the connector slides off evenly without bending the connector pins. 

 

 

3.  Carefully put the pin connector attachment back onto the pins on the end of the new 

hard drive. Work alternately at each end so that the connector slides on evenly 
without bending the connector pins. 

4.  Insert the connector through the end of the holder, and lower the drive into the holder. 

5.  Reinstall all four screws into the holder and drive case. 

To prepare a new hard disk drive 

When you install a new hard disk drive, you also need to prepare it to be able to work 
with your computer.  

•  If you want to restore the Windows software and operating system that were 

originally installed on your computer, you can do so using the Recovery CD that also 
came with your computer. See “To recover the factory installation of your hard disk” 
on page 138. 

•  If you want to use the hard disk with other than the original software and operating 

system, prepare the hard disk as described in the Corporate Evaluator’s Guide, 
available at the HP Business Support web site (www.hp.com/go/bizsupport).