Справочник Пользователя для Canon pixma ip4300
68
Troubleshooting
Printing on inappropriate type of paper.
z
Check to see if the paper you are printing on is not too thick or curled.
See “Media Types You Cannot Use” on page 5.
See “Media Types You Cannot Use” on page 5.
z
When performing Borderless Printing, print quality may be reduced at the top
and bottom edges of the paper. Make sure that the paper you are using is
suitable for Borderless Printing.
For details, refer to the Printer Driver Guide on-screen manual.
and bottom edges of the paper. Make sure that the paper you are using is
suitable for Borderless Printing.
For details, refer to the Printer Driver Guide on-screen manual.
Paper is curled.
If you are using paper with either any of the corners or the whole printing
surface curled, the paper may become dirty, not feed properly, or both. Use such
paper after correcting paper curl as follows.
(1)With the printing side (A) facing up, cover the paper with a fresh sheet of
surface curled, the paper may become dirty, not feed properly, or both. Use such
paper after correcting paper curl as follows.
(1)With the printing side (A) facing up, cover the paper with a fresh sheet of
plain paper to avoid staining or scratching the surface.
(2)Roll up the paper in a direction opposite to paper curl as seen below.
(3)Check to see that the paper curl is corrected to within approximately 0.08 to
0.2 inches / 2 to 5 mm (B) in height.
We recommend printing curl-corrected paper one sheet at a time.
Printing on thick paper.
Selecting the Prevent paper abrasion setting will widen the clearance between
the Print Head and the loaded paper. If you notice abrasion even with the media
type set correctly to match the loaded paper, set the printer to prevent paper
abrasion.
* Clear the Prevent paper abrasion check box once printing is complete, and
then click Send.
the Print Head and the loaded paper. If you notice abrasion even with the media
type set correctly to match the loaded paper, set the printer to prevent paper
abrasion.
* Clear the Prevent paper abrasion check box once printing is complete, and
then click Send.
Open the printer properties dialog box, and in Custom Settings in the
Maintenance sheet, select the Prevent paper abrasion check box, and then
click Send.
Maintenance sheet, select the Prevent paper abrasion check box, and then
click Send.
In the Canon IJ Printer Utility, select Custom Settings in the pop-up menu,
select the Prevent paper abrasion check box, and then click Send.
select the Prevent paper abrasion check box, and then click Send.
When Prevent paper abrasion is selected, the setting is also applied to direct
printing from a digital camera.
This setting can also be performed using the RESUME/CANCEL button on the
printer. With the printer on, hold down the RESUME/CANCEL button until the
POWER lamp flashes green seven times, and then release the button.
When you turn off the printer, this setting is canceled.
printing from a digital camera.
This setting can also be performed using the RESUME/CANCEL button on the
printer. With the printer on, hold down the RESUME/CANCEL button until the
POWER lamp flashes green seven times, and then release the button.
When you turn off the printer, this setting is canceled.
Cause
Action
(A)
(1)
(2)
(B)
(A)