Справочник Пользователя для Samsung wf-j1461

 

Installing the washing machine

SELECTING A LOCATION

Before you install the washing machine, select a location with the following characteristics:
•  A hard, level surface (if the surface is uneven, see “Adjusting the leveling feet,” below)
•  Away from direct sunlight.
•  Adequate ventilation
•  Room temperature that will not fall below 0˚C
•  Away from sources of heat such as coal or gas Make sure that the washing machine does 

not stand on its power cord. Ventilation openings must not be obstructed by carpeting when 
the washing machine is installed on a carpeted floor.

ADJUSTING THE LEVELING FEET

If the floor is uneven, adjust the feet (do not insert pieces of wood or any other objects under the 
feet):
1.  Loosen the leg bolt by turning it with your hand 

until it is at the desired height.

2.  Tighten the locking nut by turning it with the 

wrench.
•  Place the washer on a sturdy, flat surface. 

If the washer is placed on an uneven or weak 
surface, noise or vibration occurs.  
(Only a 1 degrees angle is allowed.)

REMOVING THE SHIPPING BOLTS

Before using the washing machine, you must remove all of the shipping bolts from the back of 
the unit. 
To remove the bolts:
1.  Loosen all bolts with the wrench before removing 

them.

2.  Take each bolt head and pull it through the wide 

part of the hole. Repeat for each bolt.

3.  Fill the holes with the supplied plastic covers.
4.  Keep the shipping bolts for future use.

installing the washing machine

oC

rpm

Min

Fuzzy control

Temp

Spin

Delay Start

Function

Door open

Power

Spin

Check

Remaining Time

Delay Start

Rinse

Wash

Pre-wash

Eco

Speedy

Wool

Delicate

Synthetic

Cotton

START

PAUSE