Справочник Пользователя для Sony HT-SF1200

D:\Chin Meng's job\SONY-HA\HT-SF1200_R2\1200_data\3210767121\GB06OTH_HT-SF1200-
CEL.fm

[HT-SF1200/HT-SS1200]

3-210-767-12

(2)

• Make sure you have connected the video 

output of your video component to the TV.

• Move your audio components away from 

the TV.

• Check the HDMI connection.

• Depending on the playback component, 

you may need to set up the component. 

Refer to the operating instructions 

supplied with each component.

• Use a 75-ohm coaxial cable (not supplied) 

to connect the receiver to an outdoor FM 
antenna as shown below. If you connect 
the receiver to an outdoor antenna, ground 
it against lightning. To prevent a gas 
explosion, do not connect the ground wire 
to a gas pipe.

• Check that the antennas are connected 

securely. Adjust the antennas and connect 
an external antenna, if necessary.

• The signal strength of the stations is too 

weak (when tuning in with automatic 
tuning). Use direct tuning (page 48).

• Make sure you set the tuning interval 

correctly (when tuning in AM stations 
with direct tuning).

• No stations have been preset or the preset 

stations have been cleared (when tuning 
by scanning preset stations). Preset the 
stations (page 49).

• Make sure that you are tuned to an FM 

RDS station.

• Select a stronger FM station.

• Contact the radio station and find out 

whether they actually provide the service 

in question. If so, the service may be 

temporarily out of order.

• For receiver operation, you can only use 

the DISPLAY button when the TUNER 

input is selected.

• Point the remote at the remote sensor on 

the receiver.

• Remove any obstacles in the path between 

the remote and the receiver.

• Replace all the batteries in the remote with 

new ones, if they are weak.

• Make sure you select the correct input on 

the remote.

• The VIDEO 3 button on the remote is not 

available for receiver operation.

AM

Receiver

To ground

Ground wire 
(not supplied) 

Outdoor FM antenna