Справочник Пользователя для Sony MDS-JE520
Editing Recorded MDs
34
EN
6
Press LEVEL/DISPLAY/CHAR to select the
character type as follows:
character type as follows:
To select
Press LEVEL/DISPLAY/CHAR
repeatedly until
repeatedly until
Uppercase letters
“A” appears in the display
Lowercase letters
“a” appears in the display
Numbers
“0” appears in the display
7
Turn AMS to select the character.
The selected character flashes.
Letters, numbers, and symbols appear in
sequential order as you turn AMS.
You can use the following symbols in titles:
The selected character flashes.
Letters, numbers, and symbols appear in
sequential order as you turn AMS.
You can use the following symbols in titles:
! ” # $ % & ’ ( ) * + , – . / : ; < = > ? @ _ `
You can press LEVEL/DISPLAY/CHAR to change
the character type at any time during Step 7 (see
Step 6).
the character type at any time during Step 7 (see
Step 6).
8
Press AMS to enter the selected character.
The cursor shifts rightward and waits for the input
of the next character.
The cursor shifts rightward and waits for the input
of the next character.
9
Repeat Steps 7 and 8 until you have entered the
entire title.
entire title.
If you entered the wrong character
Press 0 or ) until the character to be corrected
starts flashing, and repeat Steps 7 and 8 to enter
the correct character.
starts flashing, and repeat Steps 7 and 8 to enter
the correct character.
To erase a character
Press 0 or ) until the character to be erased
starts flashing, then press CLEAR.
starts flashing, then press CLEAR.
To enter a space
Press AMS while the cursor is flashing.
10
Press YES.
This completes the labeling procedure and the title
appears in the display.
This completes the labeling procedure and the title
appears in the display.
To cancel labeling
Press MENU/NO or p.
Note
You cannot label a track or an MD while you are recording
over an existing track.
over an existing track.