Справочник Пользователя для Sony power had ex dvcam dsr-400l

18

Location and Function of Parts

  Ch

ap
te

r 1  Ov

e

rv

ie

w

e “Memory Stick” slot

Insert a “Memory Stick”. The “Memory Stick” access 
indicator lights up when the “Memory Stick” is being 
accessed for reading or writing.

For details about the types of “Memory Stick”, see “About 
a “Memory Stick”” on page 123.

Do not remove a “Memory Stick” while the “Memory 
Stick” access indicator is lit. Doing so may cause a loss of 
data.

f REMOTE connector (8-pin) (DSR-450WS/

Connect a RM-B150/B750 Remote Control Unit, which 
makes it possible to control the camcorder remotely.

g DC OUT 12 V (DC power output) connector (4-pin, 

Supplies power for a WRR-861/862 UHF Synthesizer 
Tuner (optional) (maximum 0.2 A).
Do not connect any equipment other than the UHF 
synthesizer tuner.

h AUDIO IN CH-1/CH-2 (audio input channel 1/2) 

Connect other audio equipment or external microphone. 
Set the input selection switches as shown below according 
to the microphone or equipment.
MIC +48V ON (right position): For connecting to a 48 V 

microphone

MIC (center position): For connecting any microphone 

other than 48 V microphone

LINE (left position): For connecting an external audio 

signal source such as a stereo amplifier

If MIC +48V ON is selected for a microphone other than 
48 V microphone, the microphone may be damaged.

i WRR connector (7-pin)
Connect a CA-WR855 Camera Adaptor with attached 
WRR-855 UHF Synthesizer Tuner.

j

Connect to a device supporting the DV format or a 
computer, using i.LINK cable (DV cable).

• If video and audio signals from an external device 

connected to the   (i.LINK) DV OUT connector are not 
output, disconnect the i.LINK cable (DV cable) and then 
reconnect it, making sure that it is firmly seated.

• When you connect the camcorder and other equipment, 

such as a hard disk drive, with an i.LINK interface to a 
computer with i.LINK connectors, turn off the power of 
the computer, the other equipment, and the camcorder 
before connecting them using the i.LINK cable (DV 
cable). If a bus-powered type* hard disk drive or similar 
equipment is connected while the computer is powered 
on, electric current flows into the camcorder because of 
the high voltage caused by the load shift of the computer 
power, and this may cause a malfunction.

* Equipment that can be powered through i.LINK cable (DV cable)

k AUDIO OUT CH-1/CH-2 (audio output channel 1/

Output the sound being recorded or played back. Connect 
to a stereo amplifier or video monitor’s audio input 
connectors.

l VIDEO OUT connector (BNC type) 

 

Outputs a composite video signal for a video monitor. 
With a video monitor connected to this connector, you can 
monitor the picture being shot by the camera or the picture 
played back by the VTR. When synchronizing the time 
code of an external VTR with that of the camcorder, 
connect this connector to the GEN LOCK IN connector of 
the external VTR. By installing the CBK-SD01 SDI 
Output Board (optional), you can output an SDI signal 
(supporting embedded audio and the EDH function) from 
this connector. To switch the composite video signal 
output to SDI signal output, use the menu.

“Memory Stick” 
access indicator

“Memory Stick”