Справочник Пользователя для Sony power had ex dvcam dsr-400l

38

Connecting the Remote Control Unit (DSR-450WS/450WSP only)

  Ch

ap
te

r 2  Pr

ep
ar

a

tio

n

You can select the function of the REC button on the 
camcorder when the remote control unit is connected, 
using the RM REC START item on the FUNCTION 3 
page of the MAINTENANCE menu.

To disable the camcorder REC button and the 
lens VTR button
On the FUNCTION 3 page of the MAINTENANCE 
menu, set RM REC START to RM.
If the REC SWITCH function is assigned to the ASSIGN 
switch, this setting also disables these controls.

To enable the camcorder REC button and the lens 
VTR button
On the FUNCTION 3 page of the MAINTENANCE 
menu, set RM REC START to CAM.
If the REC SWITCH function is assigned to the ASSIGN 
switch, this setting also enables these controls. In this case, 
the VTR button on the remote control unit is disabled.

To enable all of the camcorder REC button, the 
lens VTR button, and the remote control unit VTR 
button
On the FUNCTION 3 page of the MAINTENANCE 
menu, set RM REC START to PARA. 
If the REC SWITCH function is assigned to the ASSIGN 
switch, this setting also enables these controls.

The MONITOR connector (BNC type) of the RM-B150/
B750 outputs the same signal as that from the MONITOR 
OUT connector on the camcorder.
Use the black cable supplied with the RM-B150/B750 to 
connect the monitor to the MONITOR connector on the 
RM-B150/B750.

The camcorder settings return to the settings in effect 
before the remote control unit was connected.
By making a menu setting, the setting of the paint 
adjustment made with the remote control unit can be 
retained even after the remote control unit is removed from 
the camcorder.

The non-volatile memory of the camcorder used for 
storing paint adjustment data consists of two regions as 
shown below: one is the “independent data region” that is 
used when a remote control unit is not connected, and the 
other is the “remote control data region” that is used when 
a remote control unit is connected. Paint adjustment data is 
automatically selected and output to the camcorder 
depending on whether or not a remote control unit, such as 
an RM-B150, is connected.

Thus, when a remote control unit is connected to the 
camcorder, the effective data region is switched to the 
“remote control data region” and the settings of the paint 
adjustment that were in effect last time the remote control 
unit was used are recalled.
Settings of the absolute value volume 

1)

 and absolute value 

switches 

2)

 are overwritten by those on the remote control 

unit after the remote control unit is connected.
When the remote control unit is removed from the 
camcorder, the “independent data region” becomes 
effective. Thus the camcorder will return to the settings 
that were in effect before the remote control unit was 
connected.

1) Absolute value volume: The data corresponding to the rotation degree 

(position) of the volume knob is output. The data corresponding to the 
rotation amount (change) is called the relative value volume.

2) Absolute value switch: Toggle switches or slide switches (except the 

temporary switches) (or controls) whose positions must coincide with their 
functions are called absolute value switches.

Non-volatile memory

MASTER BLACK
MASTER GAMMA
KNEE POINT
DETAIL LEVEL
   R/B GAIN
   R/B BLACK

MASTER BLACK
MASTER GAMMA
KNEE POINT
DETAIL LEVEL
   R/B GAIN
   R/B BLACK

Setup 
menu of the 
camcorder

RM-B150

Hardware 
of the 
camera

RM-B150 connected

RM-B150 not 
connected