Справочник Пользователя для Sony power had ex dvcam dsr-400l

58

Recording

  C
h

a

p

ter

 4

  R
e

co
rd

in

g 

an
d 

Pl

a

y

b

a

c

k

Press the DISPLAY button of the LCD monitor to 
display TC on the counter display section.

Set the PRESET/REGEN/CLOCK switch to PRESET.

Set the F-RUN/SET/R-RUN switch to SET.

The first (left-most) digit of time code flashes.

Use the arrow key to set the time code value including 
the last (right-most) digit of the time code.

To reset the time code value to 00:00:00:00, press the 
RESET button of the LCD monitor.

Set the F-RUN/SET/R-RUN switch to the desired 
operating mode for the time code generator.

F-RUN: Free run. The time code generator keeps 
running.
R-RUN: Recording run. The time code generator runs 
only while recording.

To set the DF (drop frame)/NDF (non-drop frame) 
mode
You can select the drop frame (DF) mode or non-drop 
frame (NDF) mode on the FUNCTION 1 page of the 
OPERATION menu.

When the scan mode is 24P, NDF is selected 
automatically, regardless of the menu setting (DSR-
450WS only).

To make the time code consecutive
When the F-RUN/SET/R-RUN switch is set to R-RUN, 
recording a number of scenes on the tape normally 
produces consecutive time code. However, once you 
remove the cassette and record on another cassette, the 
time code will no longer be contiguous even when you use 
again the original cassette for recording. 
In this case, to make the time code consecutive, proceed as 
follows.

Set the PRESET/REGEN/CLOCK switch to REGEN.

Use the EDIT SEARCH +FWD/–REV button to select 
the point where the recording should be start again. 

This reads the previous recording and synchronizes the 
internal time code generator, thus allowing the new 
time code to be recorded consecutively.

Setting the PRESET/REGEN/CLOCK switch to CLOCK 
saves the actual time in the time code. When it is necessary 
to set the actual time, use the TIME/DATE page of the 
DIAGNOSIS menu.

When the scan mode is 24P, the camcorder cannot record 
based on the CLOCK setting (DSR-450WS only).

By setting the user bits (up to 8 hexadecimal digits), you 
can record user information such as the date, time, or scene 
number on the time code track.

Press the DISP SEL button of the LCD monitor to 
display the STATUS screen.

Press the DISPLAY button on the LCD monitor to 
display U-BIT in the counter display section.

Set the F-RUN/SET/R-RUN switch to SET.

The first (left-most) digit flashes.

Use the arrow key to set the time code value including 
the last (right-most) digit of time code.

Hexadecimal digits A to F are displayed as A to F in 
capital letters.
To reset the user bit data to 00 00 00 00, press the 
RESET button of the LCD monitor.

Set the F-RUN/SET/R-RUN switch to the desired 
operating mode for the time code generator.

F-RUN: Free run. The time code generator keeps 
running.
R-RUN: Recording run. The time code generator runs 
only while recording.

You can synchronize the internal time code generator of 
this camcorder with an external generator for the 
regeneration of an external time code. You can also