Справочник Пользователя для Sony RM-AV2500T

Press the desired Component
Select button.

The selected component name stays
lit and “LEARN” flashes.

Press and hold down the button
on the component’s remote
control (amplifier in this example)
until you hear a beep.
(If you release the button before
you hear a beep, the signal may
not be learned correctly.)

“LEARN” stops flashing and stays lit.

Learning did not succeed. Try Steps 3 and 4
again.

Press COMMANDER OFF.

1 While pressing COMMANDER OFF,

press PROGRAM + and w +.

2 While pressing the LIGHT button,

press the Component Select button
which you want to clear.

• You can programme a signal by “learning”

for a Component Select button for which a
System Control function (page 27) or the
Power-On function (page 30) has been
programmed. In this case, the System Control
function or the Power-On function is
overwritten and cannot be used. If you clear
the “learned” signal from the button, the
System Control function or the Power-On
function is resumed, and you can use it again.

• You cannot programme a System Control

function (page 27) for a Component Select
button for which a signal has been
programmed by “learning.”

• You can programme the Power-On function

for a Component Select button for which a
signal has been programmed by “learning,”
but then the Power-On function cannot be
used. If you clear a “learned” signal from the
button, you can use the Power-On function.