Справочник Пользователя для Sony slv-se240g
74
Troubleshooting
Tim
e
r re
c
o
rd
ing
The PDC function does
not operate properly.
not operate properly.
• Check that the clock and the date are set correctly.
• Check that the PDC time you set is the correct one (there
• Check that the PDC time you set is the correct one (there
might be a mistake in the TV programme guide). If the
broadcast you wanted to record did not send the good PDC
information, the VCR will not start recording.
broadcast you wanted to record did not send the good PDC
information, the VCR will not start recording.
• If the reception is poor, the PDC signal might be altered
and the VCR might not start recording.
Syn
c
hr
o
n
ized R
ecor
d
ing
The SYNCHRO REC
button turns off while
recording or does not go
back to recording
standby mode.
button turns off while
recording or does not go
back to recording
standby mode.
• The tape has reached its end. Insert a new tape and press
SYNCHRO REC again.
The Synchronized
Recording function does
not work.
Recording function does
not work.
• The connected equipment was not turned off.
Turn off the connected equipment and press SYNCHRO
REC again.
REC again.
• There was a power failure. Press SYNCHRO REC again.
The programme recorded
with the Synchronized
Recording function is
incomplete.
with the Synchronized
Recording function is
incomplete.
• If the settings for timer recordings and Synchronized
Recording overlap, the programme that starts first has
priority and the second programme starts recording only
after the first programme has finished.
priority and the second programme starts recording only
after the first programme has finished.
• There was a power failure. Press SYNCHRO REC again.
Oth
e
rs
A tape cannot be
inserted.
inserted.
• Check that a tape is not already in the tape compartment.
The remote commander
does not function.
does not function.
• Make sure you are pointing the remote commander at the
remote sensor on the VCR.
• Replace all the batteries in the remote commander with
new ones if they are weak.
• Make sure the [TV] / [VIDEO] remote control switch is set
correctly.
The selected input line
connector number does
not appear in the display
window.
connector number does
not appear in the display
window.
• Press INPUT SELECT to display the connected line.
The tracking meter does
not appear on the TV
screen.
not appear on the TV
screen.
• The recording condition of the tape is very poor and
tracking cannot be adjusted.
You cannot control other
TVs.
TVs.
• Set your TV’s code number. The code number may change
when you replace the batteries of the remote commander.
The display window
becomes dim.
becomes dim.
• The display window automatically becomes dim when the
VCR is in standby or timer recording mode.
Symptom
Remedy