Справочник Пользователя для Sony storstation lib-d81
17
Chapter 2 Installation
Connecting the Power Cable
1
Make sure that the power switch on the rear of the AIT autoloader is in the
off position (a is depressed).
off position (a is depressed).
2
Connect one end of the power cable to the power supply connector and the
other end to the power outlet.
other end to the power outlet.
Connecting to the Host Computer
Connect the AIT autoloader and the host computer with a SCSI cable. This
section explains general connection steps. To connect, use an Ultra2 Wide SCSI
LVD cable commonly sold in stores. However, when using a model equipped
with an AIT-3 drive, use an Ultra 160/m SCSI LVD cable. The autoloader side
uses the 68-pin half pitch connector.
section explains general connection steps. To connect, use an Ultra2 Wide SCSI
LVD cable commonly sold in stores. However, when using a model equipped
with an AIT-3 drive, use an Ultra 160/m SCSI LVD cable. The autoloader side
uses the 68-pin half pitch connector.
When connecting other SCSI devices along with the AIT autoloader, see
“Connecting SCSI Peripheral Devices” (page 22).
“Connecting SCSI Peripheral Devices” (page 22).
Caution
• Do not connect the AIT autoloader to the HVD (High Voltage Differential)
SCSI bus. If connected, the autoloader or other devices on the SCSI bus may
be damaged.
be damaged.