Справочник Пользователя для Panasonic cf-72n3xxxxx

35

Confirm the following contents in [Start] - [Settings] - [Control Panel] - [System] - [Device Man-
ager] - [TEAC ****] or [MATSHITA ****] - [Settings]. Make the settings if they have not yet been

made.

Add a check mark for [DMA].
Set both [Start drive letter] and [End drive letter] in [Reserved drive letters] to [L:].

Select the [Start], then select [Shut Down].

Select [Restart in MS-DOS mode] and select [OK].

Open the "CONFIG.SYS" file for editing by issuing the following commands:
cd \   Enter
edit config.sys    Enter

Move the cursor to the line containing "OAKCDROM.SYS" and delete the characters "rem"
at the beginning of the line. (Deleting "rem" causes the item to become valid.)
DEVICEHIGH=C:\WINDOWS\COMMAND\OAKCDROM.SYS /D:MSCD000
(If this line is missing, add it.)

Press   Alt    +   F    , then   S    to save the file.  Then press    Alt    +   F   , then   X    to exit
the Edit program.

Follow the same steps to edit the "AUTOEXEC.BAT" file.
edit autoexec.bat    Enter

Move the cursor to the line containing "MSCDEX.EXE" and delete the characters "rem" at
the beginning of the line. (Deleting "rem" causes the item to become valid.)
LOADHIGH  C:\WINDOWS\COMMAND\MSCDEX.EXE /D:MSCD000 /L:L
(If this line is missing, add it.)

Press   Alt    +   F    , then   S    to save the file.  Then press    Alt    +   F   , then   X    to exit
the Edit program.

Restart the computer.

To use the CD-ROM/DVD-ROM drive in the MS-DOS mode, configure the drive following the
steps below after confirming that the above contents have been set. If the steps listed below
are performed although the above settings have not been made, the drive will not operate
properly.

The region code has been set to the following:
<For U.S.A. and Canada> Set to “1”
<For Europe>

Set to “2”

Use of another region code or alteration of the region code invalidates the warranty.  For
more information, contact Panasonic Technical Support.
If commercially available DVD playback software asks you the region code, set to the follow-
ing:
<For U.S.A. and Canada> Set to “1”
<For Europe>

Set to “2”