Справочник Пользователя для Panasonic CF-U1

37

Follow the instructions below when a problem has occurred. There is also an 
advanced troubleshooting guide in the “Reference Manual”. For a software prob-
lem, refer to the software’s instruction manual. If the problem persists, contact 
Panasonic Technical Support (  page 56). You can also check the computer’s 
status in the PC Information Viewer 
(  

 Reference Manual “Checking the Computer’s Usage Status”).

Cannot start up.

The power indicator 

or battery indicator 

is not lit.

  Connect the AC adaptor.

  Insert a fully charged battery.

  Remove the battery pack and the AC adaptor, then 

connect them again. 

  If a device is connected to the USB port, disconnect 

the device, or set [Legacy USB Support] to [Disabled] 

in the [Advanced] menu of the Setup Utility. 

(  

 Reference Manual “Setup Utility”)

The power is turned 

on but “Warming up 

the system (up to 30 

minutes)” appears.

  The computer is warming up before start up. Wait for 

the computer to start up (takes up to 30 minutes). If, 

“Cannot warm up the system” is displayed, the com-

puter failed to warm up and does not start. In this case, 

turn off the computer, leave it in an environment of  

5 °C {41 °F} or higher temperature for about an hour, 

and then turn on the power again.

Cannot turn on the 

computer.

The computer does 

not resume from 

sleep 

(

) /

standby 

(

).

(The power indica-

tor blinks quickly in 

green.)

  Leave it in an environment of 5 °C {41 °F} or higher 

temperature for about an hour, then turn on the power 

again.

The computer does 

not enter sleep 

mode while the 

screen saver is 

running. (The 

screen stays black.)

  Press and hold the power switch for four seconds or 

longer to shut down the computer forcibly (Data not 

saved will be lost). Then disable the screen saver.

U1mk2_OI_XP7.indb   37

U1mk2_OI_XP7.indb   37

2010/01/14   16:36:30

2010/01/14   16:36:30