Справочник Пользователя для Panasonic cq-c1115n

TU

N

E

/T

R

A

C

K

TU

N

E

/T

R

A

C

K

TU

N

E

/T

R

A

C

K

TU

N

E

/T

R

A

C

K

Set your car's ignition switch to the ACC or ON position.

Power on: Press [SRC] (PWR).

Press [SRC] to change the source.

(Setting Range: 0 to 40, Default: 18)
UP

:Press [

▲

Down :Press [

▼

ON: Press [MUTE]. 

(

lights.)

OFF: Press [MUTE] again.

SQ is a function that can call up various sound types at the
touch of button in accordance with your listening music
type.
Press [SQ] to select the sound type as follows:

Note: Settings of SQ, bass and treble are influenced one
another. If such an influence causes distortion to the audio
signal, readjust bass/treble or volume.

[MUTE]
toggles mute on/off.

▲

▼

adjusts the volume.

(FLAT) flat frequency response:
does not emphasize any part. (Default)

(ROCK) speedy and heavy sound:
exaggerates bass and treble.

(POP) wide-ranged and deep sound:
slightly emphasizes bass and treble.

(VOCAL) clear sound:
emphasizes middle tone and slightly empha-
sizes treble.

●

●

Verify the wiring. (battery lead, power
lead, ground lead, etc.)

●

Fuse blown (Contact the nearest
Panasonic Service Centre.)

●

Ask a professional for fuse replacement.

●

Be sure to use the same rated fuse.

●

●

Verify the wiring.

●

●

Make sure that grounding is established
properly.

●

●

Make sure that the antenna mounted
point is grounded properly.

●

●

●

●

●

The maximum permissible tilt angle is
30°.

●

Secure the unit.

●

Press [

u

]. If the disc is still not ejected,

●

●

Verify the wiring.

●

Connect the speaker lead correctly.

(The disc is ejected automatically.)
The disc is dirty, or is upside down.
The disc has scratches.

●

Check the disc.

No operation by some cause.

●

If normal operation is not restored, con-
sult your dealer or the nearest Service
Centre to ask for repairs.

Check and take steps as described below.
If the described suggestions do not solve the problem, it is recom-
mended to take the unit to your nearest authorized Panasonic Service
Centre. The product should be serviced only by qualified personnel.
Please refer the checking and the repair to professionals. Panasonic
shall not be liable for any accidents arising out of neglect of checking
the unit or your own repair after your checking.

Never take measures especially for those other than indicat-
ed by italic letters in “Check point” described below because
those are too dangerous for users to handle themselves.

¡ Do not use the unit in an irregular condition, for example, with-

out sound, or with smoke or a foul smell, which can cause
ignition or electric shock. Immediately stop using the unit and
consult your dealer.

¡ Never try to repair the unit by yourself because it is dangerous

to do so.

[TUNE ]] [TUNE []
down/up the frequency. (Hold it down for more
than 0.5 seconds and release it for seek tuning.)

[BAND]
selects a band in the radio source.
(APM) (

Auto Preset Memory)

executes APM in the radio source.
(Hold it down for more than 2 seconds.)

Preset buttons [1] to [6]
selects a preset station in the radio
source, and presets the current
station. (Hold it down for more
than 2 seconds.)

Up to 6 stations can be preset in AM (MW), FM1, FM2, and
FM3 respectively.
Preset stations can be simply called up by pressing one of the
preset buttons from [1] to [6].

With this operation, stations with good receiving conditions can
be automatically stored in the preset memory.

Select a band.

Hold down [BAND] (APM) for more than 2

seconds.

The preset stations under best receiving conditions are
received for 5 seconds each after presetting the stations
(SCAN). To stop scanning, press one of the buttons from
[1] to [6].

Note: New stations overwrite existing saved stations.

Tune into a station.

Hold down one of the preset buttons from

[1] to [6] for more than 2 seconds.

(blinks once)

Note: New stations overwrite existing saved stations.

Press [DISP] to change the display.

Press [SRC] to select the radio source.

Press [BAND] to select a band.

Select a station.

[TUNE ]]: Lower

[TUNE []: Higher

Note: Hold down either of them for more than 0.5 sec-
onds and release it for seek tuning.

Press the corresponding preset button from [1] to [6] to
tune into a preset station.

Band/frequency

Clock display

Press [SRC] to select the Disc Player

source.

Select a desired portion.

Press [6] / [7].

Note: To perform fast forward/reverse, hold down either
of them.

[7]

Previous track: [6]

Press [BAND] (y / 5).

Press again to cancel.

Press a track number button from [1] to [6].

¡ The corresponding track (1-6) starts playing.

Hold down a track number button from [1]

to [6] ((7) to (12)) for more than 2 seconds.

¡ The corresponding track (7-12) starts playing.

All the available (tracks) are played in a random sequence.

Hold down [REP] (RANDOM) for more

than 2 seconds.

Hold down again to cancel.

The current (track) is repeated.

Press [REP] (REPEAT).

Press again to cancel.

The first 10 seconds of each track is played in sequence.

Hold down [SQ] (SCAN) for more than 2

seconds.

(blinks during scanning)

Hold down again to cancel.

¡ Do not insert a disc when the 

¡ Refer to the section of “Notes on Discs”.
¡ This unit does not support 8 cm discs.

¡ If you insert an 8 cm disc and cannot eject it,turn the ignition key

to the ACC OFF position once and turn the key to the ACC ON posi-
tion again, then press [u] (Eject).

¡ Do not insert foreign objects into the disc slot.

Press [SEL] (Select) to display the audio menu display.

Note: If no operation takes place for more than 5 seconds in the audio menu (2 seconds in Main volume adjust-
ment), the display returns to the regular mode.

Press [SEL] (Select) to select a mode to

be adjusted.

Press [

▲] or [▼].

(Setting Range: 0 to 40, Default: 18)

q : 

Up

w : 

Down

(Setting Range: –12 dB to +12 dB by 2 dB,
Default: 0 dB)

q : 

Increased

w : 

Decreased

(Setting Range: –12 dB to +12 dB by 2 dB,
Default: 0 dB)

q : 

Increased

w : 

Decreased

(Setting Range: 15 levels each and 0 (center),
Default 0)

q : 

Right enhanced

w : 

Left enhanced

(Setting Range: 15 levels each, Default CNT (cen-
tre))

q : 

Front enhanced

w : 

Rear enhanced

Disc slot
takes a disc in with the printed side facing
up.

(y / 5) (Pause/Play)
toggles pause/play in the
player source.

[DISP] (Display)
switches the information on the
display.

[6] [7]
skip to the previous/next track in
the player source. 
Hold down either of them for fast
reverse/fast forward.

[REP] (Repeat)

toggles on/off the repeat play.

toggles on/off the random play. (Hold down it for
more than 2 seconds.)

[u] (Eject)
ejects the disc.

indicator

[1] to [6]

(7) to (12) (Hold down one of
them for  more than 2 seconds.)

select a track directly.

[SRC] (Source)
selects a source.

[DISP] (Display)
exits from the audio
menu.

▲

▼

selects a value in the audio menu.

[DISP] (Display)
(CLOCK)
switches the informa-
tion on the display.
sets the clock time.

[SRC] (Source)
selects a source

[SRC] (Source)
selects a source.
(PWR) (Power)
toggles power on/off.

Printed side

lights when mute is on.

Up

Down

[SQ] (Sound Quality)
selects a sound type (SQ).

Band/frequency

Clock display

[SEL] (Select)
selects items in the audio menu.

[D•M] (Direct Memory)
tunes into the station memorized in D•M.
(Hold down it for more than 2 seconds to
memorize the current station.)

[D•M] (Direct Memory)
tunes into the station memorized in D•M. (Hold
down it for more than 2 seconds to memorize
the current station.)

(Stereo) indicator

lights while receiving an FM stereo signal.

Band

Preset Number

Frequency

lights while receiving the D•M (Direct Memory)
station.

toggles on/off the scan play. (Hold down it for  more than 2
seconds.)

Track

Play time

lights when a disc is in the player.

Repeat indicator

Random indicator

Press [DISP] (Display) to change the display.

Player mode display (Default)

Clock display

Select a station you would like to preset.

Hold down [D•M] for more than 2 seconds.

Press [D•M].

Press again to cancel.