Справочник Пользователя для Panasonic cq-srx7000n

Скачать
Страница из 58
40
CQ-SRX7000N
37
E
N
G
L
I
S
H
Installation
Supplied Hardware
Fire Wall of Car
Hex. Nut (Option)
Rear Support Strap (Option)
wMounting Bolt
qMounting Collar
Tapping Screw (Option)
3 mmø
(a) Using the Rear Support Strap (Option)
Rubber Cushion 
(Option)
wMounting Bolt
qMounting Collar
Rear Support Bracket
(Provided on the car)
(b) Using the Rubber Cushion (Option)
Caution: Do not disconnect the battery terminals of a
car with trip or navigational computer since all user set-
tings stored in memory will be lost.  Instead take extra
care with installing the unit to prevent shorts.
Preparation
¡Before installation, check the radio operation with anten-
na and speakers.
¡Disconnect the cable from the negative (–) battery termi-
nal (see caution below).
¡Unit should be installed in a horizontal position with the
front end up at a convenient angle, but not more than
30°.
Dashboard
Installation
Installation Opening
The unit can be installed in
any dashboard having an
opening as shown at right.  The dashboard should be 4.5
mm - 6 mm thick in order to be able to support the unit.
Installation Precautions
This product should be installed by a professional installer,
if possible.
In case of difficulty, please consult your nearest authorized
Panasonic Service Center.
1. This system is to be used only in a 12-volt, DC battery
system (car) with negative ground.
2. Follow the electrical connections carefully (
a
Page 44).
Failure to do so may result in damage to the unit.
3. Connect the power lead (red) after all other connections
are made.
4. Be sure to connect the battery lead (yellow) to the posi-
tive terminal (+) of the battery or fuse block (BAT) termi-
nal.
5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation
instructions of the respective equipment before connect-
ing it to this unit.
182 mm
53 mm
30° or less
No.
Item
Diagram
Q’ty
q
w
e
r
t
y
Mounting Collar
Mounting Bolt (5 mm ø)
Power Connector
Removable Face Plate Case
Trim Plate
ISO Antenna Adapter
1
1
1
1
1
1