Справочник Пользователя для Panasonic cq-vx2200u
40
CQ-VX2200U
31
E
N
G
L
I
S
H
Trouble
Cause / Step
¡CD is defective.
¡Mechanical trouble.
¡Mechanical trouble.
a
Open the panel and press [u] (CD EJECT). If failure persists, press the
reset switch. If normal operation is not restored, call the store where you
purchased the unit or the nearest Panasonic Servicenter to ask for repairs.
reset switch. If normal operation is not restored, call the store where you
purchased the unit or the nearest Panasonic Servicenter to ask for repairs.
Unstable mounting.
a
Mount the unit securely with the mounting parts, referring to the section
on Installation.
on Installation.
Mounting angle is over 30 degrees.
a
Adjust mounting angle to less than 30 degrees.
CD is dirty.
a
Clean CD, referring to the section on Notes on CD.
CD is dirty.
a
Clean CD, referring to the section on Notes on CD.
CD is upside down.
a
Place CD in the correct direction with the label side up.
CD is in the CD com-
partment but no sound
is made, or CD is eject-
ed automatically.
partment but no sound
is made, or CD is eject-
ed automatically.
CD sound skips, tone
quality is low.
quality is low.
Sound skip due to
vibration.
vibration.
CD is not ejected.
■
CD
Trouble
Cause / Step
Poor quality tape.
a
Use better quality tape.
Heads are dirty.
a
Clean heads. (Ask a service representative for advice.)
Blank tape is inserted in the unit.
a
Insert recorded tape into the unit.
No sound.
Tape sound quality is
poor.
poor.
■
Cassette Tape
Troubleshooting
(continued)
Trouble
Cause / Step
Battery cable is not correctly connected.
a
Connect the battery cable to the terminal that is always live.
The motor antenna relay control lead is not connected correctly.
a
If there is a motor antenna in the car, connect the motor antenna relay control
lead to the motor antenna lead that is correctly installed in the car.
lead to the motor antenna lead that is correctly installed in the car.
The radio antenna is not extended enough.
a
Extend the radio antenna.
Station is too far, or signals are too weak.
a
Select other stations of higher signal level.
Too much noise in FM
stereo and monaural
broadcasts.
stereo and monaural
broadcasts.
Preset station is reset.
■
Radio