Справочник Пользователя для Panasonic cq-va7800n

53

52

Use the supplied Spacer i if mounting hole of your car is shaped like below.

i Spacer

o Double-Faced Adhesive Tape

t Binding-Head Screw 

(5 

mm

ø x 6 mm)

Not used

Bracket

Mounting Hole

of a Bracket

(in section)

Existing Bracket (L)
(Bracket originally
attached to the car)

o Double-Faced 

Adhesive Tape

Existing Bracket (R)

t Binding-Head Screw

(5 

mm

ø x 6 mm)

i Spacer

❏ Installation Procedures (When not using Mounting Collar w)

Use the brackets supplied with your car when mounting this unit. The bracket shape and mounting method vary with car
manufacturers, car types and manufacturing year. Please consult your nearest dealer or installer.

Select mounting screws according to the hole positions and hole shape of the bracket.

y Flat-Head Screw (5 

mm

ø

x 6 mm)

4 pieces

u Binding-Head Screw (4 

mm

ø

x 3 mm)

4 pieces

t Binding-Head Screw (5 

mm

ø

x 6 mm)

2 pieces

Recycle the Binding-Head Screws that fixed the transportation brackets for two more 
positions.

When using these

mounting holes

Attach the seal side of the Velcro Tape !6
to the hide-away unit, then mount the unit
on the carpet.

Note: Some carpet materials may not be
suitable for this mounting method. In this
case, please contact the shop where you
purchased this product.

❑ Unit installation by using the Mounting Brackets !3 and the Base Brackets !4.

!2 Hex. Nut (5 

mm

ø)

!2 Hex. Nut (5 

mm

ø)

Carpet

!3 Mounting Bracket

!0 Binding-Head Screw

(5 

mm

ø x 8 mm)

!0 Binding-Head Screw

(5 

mm

ø x 8 mm)

!1 Tapping Screw (6 

mm

ø x 20 mm)

!1 Tapping Screw (6 

mm

ø x 20 mm)

!5 Double-Faced Adhesive Tape

Drill for 4.8 mm diameter holes to the chassis.
* Put the tape and the base bracket together with each hole of the tape and

bracket connected so that the screw goes in at two positions.

!4 Base Bracket

Note: Apply an anticorrosive to the holes and tapping screws.

❑ Mount the unit on the car carpet by using Velcro Tape !6.

Cautions: 
¡

Never mount the unit in any of the following locations to avoid damage due to overheating;

1. Near the heater port.
2. Places like the dashboard or rear deck, where it may be exposed to direct sunlight.

¡

Do not mount the unit near the door, where it could be exposed to rain.

Caution: You run the risk of interfering with the mounting or causing damage by drilling into the gas tank, a wiring
harness, or other component.

!6 Velcro Tape

Make cuts by using cutter.

Let the bolts of the base bracket
pass the carpet.