Справочник Пользователя для Panasonic dmr-e100heb
∫ Before Use
17
Auto Setup automatically tunes all available stations and sets the
DVD Recorder’s clock to the current date and time.
DVD Recorder’s clock to the current date and time.
[1] Switch the TV on.
[2] Select the AV input on your TV.
[3] Press [DVD,
[2] Select the AV input on your TV.
[3] Press [DVD,
Í] to switch
the DVD
Recorder
on.
the DVD
Recorder
on.
≥Auto Setup starts. This takes about 5 minutes.
≥(If connected to your TV using the RF lead only)
≥(If connected to your TV using the RF lead only)
Select an unused channel pre-set on your TV and tune it to
the RF output channel number shown on the DVD Recorder
display (or until you can clearly see the Auto Setup screen).
Store the new video playback channel (refer to the
instructions for your TV).
the RF output channel number shown on the DVD Recorder
display (or until you can clearly see the Auto Setup screen).
Store the new video playback channel (refer to the
instructions for your TV).
[4] To set up the Owner ID, repeat the
steps 2–7 on the previous page.
In some cases, interference (lines or patterning) or a very
poor picture may appear on the TV when the DVD Recorder is
connected. If this happens, follow the steps below to change
the video playback channel (RF output channel) to remove the
interference.
poor picture may appear on the TV when the DVD Recorder is
connected. If this happens, follow the steps below to change
the video playback channel (RF output channel) to remove the
interference.
[1] Press [FUNCTIONS] for more than 5
seconds.
The RF output channel number is displayed on the unit display.
[2] Press the numeric buttons, [
3, 4] or
[CH,
W, X] to select a channel number,
which differs by 2 or 3 from the
present channel number.
present channel number.
≥(For example, if the original channel number was 28, enter
31.)
≥Set the RF output channel of the DVD Recorder to [ss]
(RF OFF) when the DVD Recorder is connected to the TV via
the 21-pin Scart cable.
Press the numeric (0) button or [CH,
the 21-pin Scart cable.
Press the numeric (0) button or [CH,
W, X] to display [ss].
Skip the step 4, if using a 21-pin Scart cable.
[3] Retune your TV until you receive the
Test pattern.
≥It may be necessary to repeat steps 1 and 2 above until you
can see the Test pattern clearly.
[4] Press [ENTER] to finish this setting.
Auto Setup (without Q Link Functions)
RETURN
Auto-Setup
Ch 4
Auto-Setup in progress, please wait.
RETURN : to abort
RETURN : to abort
Removing Interference
TV screen
The picture with interference
Unit display
Indication when the RF output
channel is 28 (example)
channel is 28 (example)
Test pattern indication
RF OUTPUT CHANNEL
DVD
CH : 28
RETURN
SELECT
ENTER
Indication after changing the RF
output channel to 31 (example)
output channel to 31 (example)
Unit display
Test pattern indication
RF OUTPUT CHANNEL
DVD
CH : 31
RETURN
SELECT
ENTER
<Before Changing>
<After Changing>
21
68
(RF OFF)
...
The clear picture
DVD(B).book 17 ページ ２００３年８月５日 火曜日 午後３時３０分