Справочник Пользователя для Panasonic proline lq-drm200

RQT7237

Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do
not solve the problem:
In the U.S.A., go to http://www.panasonic.com/broadcast.
In Canada, contact the Panasonic Canada Inc. Customer Care Centre at 1-800-561-5505, or visit the website (www.panasonic.ca), 
or an authorized Servicentre closest to you.

≥

When progressive output is on, refer also to “Progressive video” below.

≥

Insert the AC power supply cord securely into a known active AC outlet.

≥

This is a power saving feature. You can turn it off if you would prefer (Set Up—Off Timer—
Off). Press [

Í

, DVD POWER] to turn the unit on.

≥

One of the unit’s safety devices may have activated. Press [

Í

, DVD POWER] to turn the unit

on.

≥

Some operations may be prohibited by the disc.

≥

The unit is hot (“U14” appears on the display). Wait for “U14” to disappear.

≥

One of the unit’s safety devices may have activated.

Reset the unit as follows:

1.Press [

Í

, DVD POWER] to switch the unit to standby.

If the unit doesn’t switch to standby, press and hold [

Í

, DVD POWER] for about 10

seconds. The unit is forcibly switched to standby.
Alternatively, disconnect the AC power supply cord, wait one minute, then reconnect it.

2.Press [

Í

, DVD POWER] to turn the unit on.

≥

Make sure that the television is connected to the AUDIO/VIDEO terminals, S-VIDEO OUT
terminal or COMPONENT VIDEO OUT terminals on this unit.

≥

Make sure that the television’s input setting (e.g., VIDEO 1) is correct.

≥

You have set “TV Type” to “Aspect 4:3 & 480P” or “Aspect 16:9 & 480P” in the TV Screen
menus, but the television isn’t compatible with progressive signals. Press and hold [

∫

] and

[TIME SLIP] on the unit at the same time for about 5 seconds. The setting will change to
interlace.

≥

This can occur because the signals are being divided between the unit and the television. 
It can be solved by using a signal booster, available from audio-visual suppliers. Consult your
dealer if reception does not improve.

≥

Check the settings on your television.

≥

Check the settings for “TV Type”, “4:3 TV Settings for DVD-Video” or “4:3 TV Settings for
DVD-RAM” in the TV Screen menu.

≥

Go to the Display menu and select “Automatic” for “Status Messages”. 

≥

Press [STATUS] to show the on-screen messages constantly. 

≥

Go to the Display menu and select “On” for “Blue Background”.

≥

Change the settings for “3D NR”, “Block NR”, and “Mosquito NR” to “0” or turn “MPEG-DNR”
off if it is on.

≥

Play may stop where two play lists join, but this is not a malfunction.

≥

Set “Progressive” to “OFF”. This problem is caused by the editing method or material used on
DVD-Video, but should be corrected if you use interlace output.

≥

The effect is less perceivable with some types of video.