Справочник Пользователя для Panasonic sc-pt450

RQT8043

RQTX0066

7 Progressive video 

•  This problem is caused by the editing method or material used on DVD-Video, 

but should be corrected if you use interlaced output. Set “Video Output Mode” in 
Picture Menu to “480i” or “576i”. (Alternatively, press and hold [CANCEL] to switch 
to “480i” or “576i”.)

•  Disable the HDMI AV OUT connection and use other video connections. Make the 

settings in the following order:

1  Set “Video Mode” in the “HDMI” tab to “Off”.
2  Set “Video Output Mode” in Picture Menu to “480i” or “576i”. (Alternatively, press 

and hold [CANCEL] to switch to “480i” or “576i”.)

20

24
20

•  Select “480p” or “576p” in “Video Output Mode” in Picture Menu.
•  The unit’s VIDEO OUT terminal outputs an interlaced signal even if “PRG” is 

displayed.

20

9

•  When HDMI or progressive output is on, closed captions will not be displayed.

—

7 Unit displays

•  Select “Bright” in “FL Dimmer” in the “Others” tab.

25

•  You inserted a disc the unit cannot play; insert one it can.
•  You inserted a blank disc.
•  You inserted a disc that has not been fi nalized.

11
—
—

•  You have not inserted a disc; insert one.
•  You have not inserted the disc correctly; insert it correctly.

—

14

•  Check and correct the speaker cable connections.
  If this does not fi x the problem, consult the dealer.

8

•  There is a power supply problem. Consult the dealer.

—

•  Disc may be dirty. Wipe it clean.

26

•  Incorrect operation performed. Read the instructions and try again.

—

& &”

& & &”

& stands for a number.

•  Trouble may have occurred. The numbers following “H” and “F” depend on the 

status of the unit. Turn the unit off and then back on. Alternatively, turn the unit off, 
disconnect the AC mains lead, and then reconnect it.

•  If the service numbers fail to clear, note the service number and contact a qualifi ed 

service person.

—

—

&”

& stands for a number.
The actual number following “U70” 
will depend on the state of the main 
unit.

•  The HDMI connection acts unusually.
  – The connected equipment is not HDMI-compatible.
  – The HDMI cable is too long.
  – The HDMI cable is damaged.

 

—
—
—

•  Match the modes on the main unit and remote control. Depending on the number 

being displayed (“1” or “2”), press and hold [ENTER] and the corresponding 
numbered button ([1] or [2]) for at least 2 seconds.

33

7 Television displays

•  The operation is prohibited by the unit or disc.

—

•  You are trying to display an incompatible group or content.

—

•  You are trying to play a protected group or content. You cannot play it.

—

•  This disc may be dirty.

—

•  Only DVD-Video discs that include or have the same region number as the one on 

the rear panel of this unit can be played.

Cover 

page

•  Select “On” in “On-Screen Messages” in the “Display” tab.

25

•  When using the HDMI connection, audio/video information is continually 

transferred between the main unit and the television regardless of which source 
has been selected on the main unit. This is normal.

—

7 Listening to the radio

•  Adjust the position of the FM antenna.
•  Use an outdoor antenna.

—

31

•  Turn the television off or move it away from the unit.

—

RQTX0066-L_new12.indd   36

RQTX0066-L_new12.indd   36

3/21/07   9:58:51 AM

3/21/07   9:58:51 AM