Справочник Пользователя для Panasonic sdr-h250gc

LSQT1212

Press the recording start/stop button again to pause 
recording.
≥ [¥] and [;] are red during recording. Do not move 

this unit until [;] is green.

The images recorded between pressing the recording start/stop button to start recording and pressing it 
again to pause recording become one scene.
However if the recording destination is the HDD, the scene is automatically divided when the recorded 
data exceeds 4 GB. (The recording will continue.)
≥ When about 5 minutes have passed without any operation in recording pause, the unit automatically 

turns off to prevent the battery from running down. When you want to use the unit, turn it on again.
This setting can also be set to [OFF]. (l 190, [POWER SAVE])

A Recording mode
B Selected recording destination
C Remaining time left for recording

(When the remaining time is less than 1 minute, [R 0h00m] 
flashes red.)

D Recording time elapsed

≥ Sound is recorded from the internal stereo microphone on the front of the unit. Take care not to block 

this microphone.

≥ If the write protection switch on the SD card is set to LOCK, it cannot be used for recording. (

l 118)

≥ Each time the unit enters the recording pause mode, the counter display will be reset to “0h00m00s”.
≥ While motion picture recording is in progress, the recording will not stop even if the LCD monitor is 

closed.

≥ While motion picture recording is in progress, do not disconnect the AC adaptor or remove the 

battery. If you do, a repair message may be displayed when the power is turned back on. (l 195, 

About recovery)

B

A

C
D

LSQT1212_GC(EN).book  138 ページ  ２００７年２月１５日　木曜日　午前１０時１３分