Справочник Пользователя для Panasonic sc-vk850
23
RQTV0148
ENGLISH
Press and hold [t] or [y] until the frequency starts scrolling to start
automatic tuning. Tuning stops when a station is found.
automatic tuning. Tuning stops when a station is found.
“ST” is displayed when a stereo FM broadcast is being received.
If noise is excessive in FM
Press [PLAY MODE] to display “MONO”.
To cancel, press [PLAY MODE] again.
The mode also cancels when you change the frequency.
Press [PLAY MODE] to display “MONO”.
To cancel, press [PLAY MODE] again.
The mode also cancels when you change the frequency.
■
AM frequency step (main unit only)
The step is factory-set to 9 kHz, but you can change it to receive broadcasts
allocated to 10 kHz steps.
1. Select “FM”.
2. Press and hold [TUNER, BAND] on the main unit.
After a few seconds the display changes to show the current minimum
allocated to 10 kHz steps.
1. Select “FM”.
2. Press and hold [TUNER, BAND] on the main unit.
After a few seconds the display changes to show the current minimum
frequency. Continue to hold the button down. The minimum frequency
changes and the step is changed.
changes and the step is changed.
To return to the original step, repeat the above steps.
Any preset stations are cleared by this procedure. Preset them again.
•
The radio
1
Select “FM” or “AM”.
FM AM MUSIC P.
2
Select the
frequency of the
desired station.
frequency of the
desired station.
3
Adjust the
volume.
volume.
1
To enter manual
presetting mode.
presetting mode.
(“PGM” appears)
2
Select the frequency of
the desired station.
the desired station.
3
The station occupying a channel is erased if another station is
preset in that channel.
preset in that channel.
Note
Preset channels to make selection simpler. Up to 15 stations can each be set in the FM and AM bands.
Automatic presetting
Tune to the frequency where presetting is to begin (➡ see
above).
above).
Press and hold.
(release when “AUTOCH1” appears)
Preset tuning
Press while the station is flashing
to select the channel.
to select the channel.
The tuner presets the stations it can receive into the channels in
ascending order.
When finished, the last station to be set is played.
ascending order.
When finished, the last station to be set is played.
or
Selecting channels
For the remote control only
1
Press [TUNER/MUSIC P.] to select “FM” or “AM”.
2
Press the numbered buttons or [u, 2/REW] or
[i, 1/FF] to select the channel.
Manual presetting
The radio
Manual tuning
Numbered
buttons
CANCEL
u
, i,
2
/REW, FF/1
VOLUME,
+, –
+, –
t
, y,
SLOW/
SEARCH
SEARCH
ENTER
TUNER/
MUSIC P.
23