Справочник Пользователя для Panasonic tx-26lxd7
48
Problem
Actions
Screen
Sound
DVB
•
Due to the digital reception technologies involved, quality of the DTV signals may be relatively low in
some cases, despite good reception of analogue programmes.
some cases, despite good reception of analogue programmes.
Chaotic image, noisy
•
Set “P-NR” in the Picture Menu (to remove noise). (p. 22)
•
Check nearby electrical products
(car, motorcycle, fluorescent lamp).
(car, motorcycle, fluorescent lamp).
The remote control
does not work
does not work
•
Are the batteries installed correctly? (p. 6)
•
Has the TV been switched On?
TV goes into
“Standby mode”
“Standby mode”
•
Off Timer function is activated.
•
The TV enters “Standby mode” about 30 min. after broadcasting
ends.
ends.
Unusual image is displayed
•
Turn off the TV with Mains power On / Off switch, then turn it on
again.
again.
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
equipment are unusual
when the equipment is
connected via HDMI
•
Is the HDMI cable connected properly? (p. 42)
•
Turn Off the TV and equipment, then turn them On again.
•
Check an input signal from the equipment. (p. 46)
•
Use an equipment compliant with EIA/CEA-861/861B.
Sound is unusual
•
Set the sound setting of the connected equipment to
“2ch L.PCM”.
“2ch L.PCM”.
•
Check the “HDMI Input” setting in the Sound Menu. (p. 22)
•
If digital sound connection has a problem, select analogue
sound connection. (p. 39)
sound connection. (p. 39)
Interference or
frozen / disappearing
image in DVB
frozen / disappearing
image in DVB
•
Check “DVB Signal Condition”. (p. 32)
If “Signal Quality” or “Signal Strength” are displayed in red,
check aerial.
If problem persists, consult your local Panasonic dealer.
If “Signal Quality” or “Signal Strength” are displayed in red,
check aerial.
If problem persists, consult your local Panasonic dealer.
•
Turn the TV off with the Mains power On / Off switch, then turn
it On again.
it On again.
Sound level is low
or sound is distorted
or sound is distorted
•
Sound signal reception may be deteriorated.
•
Set “NICAM” (p. 22) in the Sound Menu to “Off”.
(Analogue only)
(Analogue only)
No sound is produced
•
Is “Sound mute” active? (p. 7)
•
Is the volume set to the minimum?
Blurry or distorted image
(no sound or low volume)
•
Reset channels. (p. 30)
No image can be
displayed
displayed
•
Is “Colour” or “Contrast” in the Picture Menu set to the minimum?
(p. 22)
(p. 22)
HDMI
Other
An error message appears
•
Follow the message’s instructions.
•
If the problem persists, contact the authorized Service Centre.
FAQs