Справочник Пользователя для Panasonic wv-cu151

-2-

The Panasonic System Controller WV-CU151 is designed
for use with the Combination Camera WV-CS600 / WV-
CS400 or Receiver WV-RC100 / WV-RC150 / WV-RC170.

Multiplexed control signal on the video signal over a single

coaxial cable saves the expense of wiring cost.
The built-in alarm output connector allows to supply the
alarm signal to the external equipment.

1. Setting and selection of the Program menu are avail-

able.

2. Controllable functions are manual panning and tilting

of the Pan-tilt Head, Focus/Zoom/Iris Control for a
specified lens, Power on/off of the camera Wiper and
Defroster on/off Auxiliary relay on/off selection.

• Do not attempt to disassemble the instrument. In order

to prevent electric shock, do not remove screws or
covers. There are no user-serviceable parts inside.
Do refer all servicing to qualified service personnel.

• Do not abuse the instrument. Avoid striking, shaking,

etc. It could be damaged by improper handing or stor-
age. Do handle the instrument with care.

• Do not use strong or abrasive detergents when clean-

ing the instrument body. Do use a dry cloth to clean
the instrument when dirty. In case the dirt is hard to
remove, use mild detergent and wipe gently.

• Do not expose the instrument to water or moisture, and

do not operate in wet area. Do take immediate action if
ever the instrument does become wet. Turn the power
off and refer servicing to qualified service personnel.
Moisture can damage the instrument and also create
the danger of electric shock.

• Do not use the instrument in an extreme environment

where high temperature or high humidity exist. Use the
instrument under conditions where temperature are
within under conditions where temperature are within

−

10°C - +50°C, and humidity is below 90%.

• Make sure before installing pan-tilt head or lens if they

are usable.

• Set the Mode Selection Switch (LOCAL/REMOTE) on

the specified camera to the REMOTE position when
connecting it with this unit.

• Audio transmission is not available.
• Multiple operation of the unit is available.
• Every necessary procedure with regard to installing

this product should be made by qualified service per-
sonnel or system installers.

• The input power source must be 230 - 240V AC for

WV-CU151/A and WV-CU151/B, 230V AC for WV-
CU151/G  at 50Hz.